Charging The Hair Clipper; Ac Operation - Panasonic ER1411 Operating Instructions Manual

1
1
Slide the power switch to
"0·CHARGE".
2
2
Plug in the AC adaptor into a
household outlet.
3
3
Insert the appliance plug into the
clipper.
•
•
•
•

AC operation


If you connect the AC adaptor to the clipper in the same way as for charging,
and turn on the power, you can use it even if the battery capacity is low.
•
If the clipper does not operate, charge the clipper for approximately
1 minute.
•
Be careful not to discharge the battery completely with the power left turned
on. It results in shortening the battery life.
ER1411_AUS_JABARA.indd

Charging the hair clipper

Charge status ( ) lamp glows in red and charging starts.
Charging is completed when Charge status (
once every second. (Max. 1 hour later)
10 minutes after charging is completed, the charge status
( ) lamp blinks in red once every  seconds.
1 full charge will provide approximately 80 minutes of continuous
operation.
4
) lamp blinks in red
4
2010/06/02 20:00:02