Table of Contents
Advertisement
MAKE SURE YOU HAVE RECEIVED ALL PARTS:
Check your packing list to verify that all listed parts have been received. You should have the following:
•
Unvented gas log grate/burner assembly.
•
Installation/operating instructions.
•
Ceramic fiber logs.
•
Two (2) anchoring screws.
•
Plastic bag containing crushed volcanic rock.
The millivolt controlled version of this heater is the only style designed to be operated with optional devices for ON/OFF
functions. The following options may be used with the millivolt controlled heater. These options are not packaged with the
log set.
•
Hand held Remote w/receiver.
•
Wall Switch with 15' wire.
•
Wall T-stat with 15' wire.
•
Hand held Thermostat Remote w/receiver.
Handle the gas log burner assembly by the grate only. Do not pick the unit up by the
burners.
Gloves are recommended when handling ceramic fiber logs to prevent skin irritation
from loose fibers. Logs are fragile — handle with care.
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer
from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have
all parts in good condition.
What you will need for installation:
You must have the following items available before proceeding with installation:
•
External regulator (for propane/L.P.G. and
•
Piping which complies with local codes
•
Pipe sealant approved for use with propane/L.P.G. (Resistant to sulfur compounds)
•
Manual shutoff valve
•
Sediment trap (recommended)
•
Tee joint
•
Pipe wrench or appropriate size crescent wrench set
•
Screwdriver
•
Drill, with 5/32 bit
14D9999
1
/
lb. natural gas systems only)
2
GETTING STARTED
5
Hide quick links:
Advertisement
Table of Contents
