Getting Started - Monessen Hearth DEB20 Installation And Operating Instructions Manual

MAKE SURE YOU HAVE RECEIVED ALL PARTS:
Check your packing list to verify that all listed parts have been received. You should have the following:
• Unvented gas log grate/burner assembly
• Installation/operating instructions
• Ceramic Fiber logs
The milli-volt controlled version of this heater is the only style designed to be operated with optional devices for
ON/OFF functions. The following options may be used with the milli-volt controlled heater. These options are not
packaged with the log set.
• Hand held Remote with receiver
• Wall switch with 15' wire
• Thermostat sensor
The following options may be used with Hi/Lo control heater.
• Hand held Remote with receiver
• Handle the gas log burner assembly by the grate only. Do not pick the unit up
by the burners.
• Gloves are recommended when handling ceramic fiber logs to prevent skin irritation
from loose fibers. Logs are fragile — handle with care.
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the
dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you
have all parts in good condition.
WHAT YOU WILL NEED FOR INSTALLATION:
You should have the following items available before proceeding with installation:
• External regulator (for propane/LPG and 1/2 lb. natural gas systems only)
• Piping which complies with local codes
• Screwdriver
• Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)
• Drill with 5/32 bit
• Manual shutoff valve
44D0060
• Two (2) Plastic bags containing crushed volcanic rock
• Two (2) anchoring screws
• Wall thermostat with 15' wire
• Hand held Thermostat Remote with receiver
• Sediment trap (recommended)
• Tee joint.
• Pipe wrench or appropriate size crescent wrench set

GETTING STARTED

5