Jensen VX6020 Installation Manual page 2

Optional Equipment
• Steering Wheel Control (SWC)- The VX6020 is SWC ready for vehicles equipped with the option. See wiring diagram
for installation details.
• Rear Camera- The VX6020 is Rear Camera ready for vehicles equipped with the option. See wiring diagram for
installation details.
Disconnect the Battery
• To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation.
NOTE: If the VX6020 is to be installed in a car equipped with an on-board drive or navigation computer, do not
disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these
conditions, use extra caution during installation to avoid causing a short circuit.
Replacing the Fuse
• When replacing the vehicles Radio fuse always use the proper rated replacement fuse. Using a fuse with an improper
rating could damage the unit and cause a fire.
ISO-DIN Installation
The VX6020 is designed to fit into a 2.0 DIN dashboard opening. The unit has threaded holes in the chassis side panels
which may be used with the original factory mounting brackets of some Toyota, Nissan, Mitsubishi, Isuzu, Hyundai
and Honda vehicles to mount the radio to the dashboard. Please consult with your local car stereo specialty shop for
assistance on this type of installation.
1. Remove the existing factory radio from the dashboard or center
console mounting. Save all hardware and brackets as they will be
used to mount the new radio.
2. Remove the factory mounting brackets and hardware from the
existing radio and attach them to the new radio.
CAUTION! Do not exceed M5 X 6MM screw size. Longer screws may
damage components inside the chassis.
3. Place the radio in front of the dashboard opening so the wiring can
be brought through the mounting sleeve. Follow the wiring diagram
carefully and make certain all connections are secure and insulated
with wire nuts or electrical tape.
connections, plug the ISO connectors into the mating sockets on
the rear of the chassis. Turn the unit on to confirm operation (vehicle
ignition switch must be "on"). If the unit does not operate, re-check all
wiring until the problem is corrected.
4. Mount the new radio assembly to the dashboard or center console
using the reverse procedure in step 1 above.
CAUTION! Be careful not to damage the car wiring.
NOTE: It is the end-users responsibility to install and operate this unit in a manner in accordance with local, state and
federal laws. The PARKING BRAKE wire MUST BE CONNECTED as directed in the manual.
Using the Cosmetic Trim Ring
A cosmetic trim ring is supplied with the head unit for installation flexibility.
This unit will fit into most import dashes with little or no modification to the
dash board/cavity. Some US domestic vehicle dashes will accept a Double-
DIN chassis, but there is usually a small gap between the radio and dash
piece after installation is complete. In this case, use the appropriate trim
ring to conceal any gaps that may be present.
NOTE: For proper operation of the CD/DVD player, the chassis must be mounted within 30° of horizontal. Make sure
the unit is mounted within this limitation.
After completing the wiring
1
Step 1-b
Step 1-c
TAB
DASHBOARD
Step 2
Step 5-c