SATO CX400 Service Manual page 19

Section 3: Operation
For Eye-Mark Detection
1. Install both printer ribbon and print media while in the TT mode.
2. Send the following commands to the printer: <ESC>A <ESC>&11 <ESC>Z.
3. Allow 5 seconds for the printer to complete the process.
For Label-Gap Detection
1. Install print media into the printer while.
2. Place the printer in the TT mode by sending <ESC>A <ESC>CP1 <ESC>Z.
3. Send the following commands to the printer: <ESC>A <ESC>&10 <ESC>Z.
4. Allow 5 seconds for the printer to complete the process.
0.75" (19mm)
PRINT HEAD
EYE-MARK ON
BOTTOM OF LINER
BACKING PAPER INSIDE EDGE
Page 3-4
0.06" (1.5mm) =NON-PRINT
LABEL
0.25" (5.0mm)
MIN. LENGTH
= 0.59" (15mm)
LABEL
LABEL INSIDE EDGE
0.06" (1.5mm) = NON-PRINT
Figure 3-3, Label Stock Diagram
PN 9001110A
GAP, NOTCH, OR BAR WIDTH
MIN: 0.04" (2mm)
MAX. 1.0" (25mm)
MIN LABEL PITCH
0.39" (10mm)
SATO CX400 Service Manual