Advertisement
Test and Boot Up of the SC5300 Console
After turning on the power to the SC5300 Console it will perform a lamp test to illustrate to you that
all of the LED indicators are in proper working order. The LEDs will turn on and then off, chase from
left to right, top to bottom and then turn on and off again.
Once this lamp test is complete the SC5300 Console will complete its boot up process and self test
and be ready for use. For details on how to confirm that the unit is communicating with the rest of
the network properly refer to your Raynok software guide.
SC5300 Console Manual Control Joystick
The Manual Control Joystick is available for the operator to use to control individual or non-linked
axis or axis groups for simple jog moves.
Basic Operation
1.
BEFORE USING YOUR SC5300 CONSOLE LOCAL MANUAL CONTROL
JOYSTICK, BE SURE YOU UNDERSTAND AND FOLLOW ALL BASIC SAFETY
GUIDELINES AS LAID OUT BY YOUR SYSTEM ADMINISTRATOR.
2.
Select an axis by highlighting it on your monitor with your mouse. Refer to your
Raynok Software guide for details on how to do this properly.
3.
Allow the joystick to sit in its centre "off" position without the aid of your hand.
4.
Press and hold the Joystick Enable button on the top of the joystick.
5.
Wait approximately 2 seconds for the drive to produce torque and engage the brake
relays.
6.
You should see the status of the selected axis change to Jogging. Refer to your
Raynok Software guide for details on the Status Column display
7.
While looking at the machine, scenery or load in motion, gently ease the joystick in
the direction of intended travel.
8.
Ease up on the joystick as you approach the intended stopping point.
9.
For a quick stop, release the Drive Enable button. (CAUTION: BE certain that a
quick stop will NOT damage attached equipment BEFORE attempting to release the
Drive Enable while in motion)
SceneControl
®
5000 HARDWARE
SceneControl
®
5000 HARDWARE
15
Advertisement
