J.R. Clancy SC5300 User Manual page 16

SceneControl ® 5000 HARDWARE
RAYNOK Basic Procedures
To Move Battens
Reset E-Stop system
Setup Menu - "EXIT E-STOP RESET MODE"
Select batten
Set target by using any of the following
1. Use "INTRIM" macro
2. Use "OUTTRIM" macro
3. Or use "ASK TARGETS" macro
Reset Axis
Press "GO" to initiate movement
Press "STOP" to stop if needed
Press "CLEAR" to deselect all battens
Press "MANUAL CUE" twice to clear targets
Select another batten
And so on....
To Jog Battens
Select batten.
Reset Axis
Press down the button on top of the joystick to start the machine, and move the joystick in desired
direction and to jog the batten
14
SceneControl ® 5000 HARDWARE