Programmes Table - Zanussi ZWY 1100 User Manual

The maximum spin speeds are :
for Cotton, Eco : 1000 rpm (ZWY1100), 800 rpm
(ZWY180), for Wool, Handwash : 1000 rpm (ZWY1100),
800 rpm (ZWY180), for Synthetics : 800 rpm
(ZWY180/1100), for Delicates : 700 rpm.
At the end of the programme, if you have selected "Rinse
hold" , you then need to select a "Spin"
programme to finish the cycle and empty the water.
Selecting options
You must select the different options after selecting the
programme and before pressing the "Start/Pause"
pushbutton (see "Programmes table"). Press the desired
button(s) : the corresponding lights come on. If pressed
again, the lights go out. If one of the options is not com-
patible with the selected programme, the "Start/Pause"
pushbutton flashes red.
"Prewash" option
The appliance runs a prewash at 30°C max.
"Super quick" option
The washing time will be reduced depending on the pro-
gramme selected.
"Rinse plus" option
The washing machine will add one or more rinses during
the cycle. This option is recommended for people with
sensitive skin and in soft water areas.
Temporary : Press the "Rinse plus"
option is only active for the selected programme.
Permanent : Hold down the "Options"
plus" pushbuttons for a few seconds. The option is
permanently activated, even if the appliance is switched
off. To deactivate it, repeat the process.
Start of the programme
Press the "Start/Pause" pushbutton to start the cycle. The
corresponding light will come on green. It is normal for
Stand by: once the programme has finished after a
few minutes the energy saving system is enabled

Programmes table

Programme / Type of washing
Cotton (cold - 90°) : White or colour, e.g. nor-
mally soiled work clothes, bed linen, table linen, body
linen, towels.
the programme selector to remain stationary during the
cycle. The light corresponding to the current cycle is illu-
minated.
or "Drain"
Interrupting a programme
Adding washing during the first 10 minutes
Press the "Start/Pause"
ing light will flash green while the appliance is paused.
The lid can only be opened around 2 minutes after the
washing machine has come to a stop. Press the "Start/
Pause"
Modifying the programme in progress
Before making any changes to the current programme,
you need to pause the washing machine by pressing the
"Start/Pause"
possible, the "Start/Pause"
a few seconds. If you still decide to change the pro-
gramme, you must cancel the current programme (see be-
low).
Cancelling the programme
If you want to cancel the programme, turn the programme
selector to the "Stop" position
End of the programme
The washing machine stops automatically, the "Start/
Pause"
pushbutton. The
cle"
minutes after the washing machine has come to a stop.
and "Rinse
Turn the programme selector to the "Stop" position
Remove washing. Unplug and close water inlet tap.
with the pilot lights switched on. By pressing any button
the appliance will come out of the energy saving status.
Load
5,0 kg
+ : Prewash + Wash
+ : Rinses + Spin
: End of cycle
pushbutton : the correspond-
pushbutton again to continue the programme.
pushbutton. If the modification is not
pushbutton goes out and the light "End of cy-
comes on. The lid can only be opened around 2
Possible options
Prewash, Super quick, Rinse plus, Rinse
hold
pushbutton flashes red for
.
.
5