Get Started; Charging; Charge Your Headset; Manual/Nfc Pairing - Philips M2BT User Manual

3 Get started

Charge your headset

Note
•
Before you use your headset for the first time, charge
the battery for 5 hours for optimum battery capacity
and lifetime.
•
Use only the original USB charging cable to avoid any
damage.
•
Finish your call before charging the headset, as
connecting the headset for charging will power the
headset off.
•
You can operate the headset normally during charging.
Connect the supplied USB charging cable to:
• the micro USB charging slot on the
headset and;
• the charger/USB port of a computer.
» LED turns white during charging and
turns off when the headset is fully
charged.
Tip
•
Normally, a full charge takes 3 hours.
•
When your battery is empty, you can carry on listening
music with an audio cable. Make sure the headset is off
(and not in idle mode) before using this audio cable.
Pair the headset with your
mobile phone
Before you use the headset with your mobile
phone for the first time, pair it with a mobile
phone. A successful pairing establishes a unique
encrypted link between the headset and mobile
phone. The headset stores the last 8 devices
in the memory. If you try to pair more than 8
devices, the earliest paired device is replaced by
the new one.
There are two ways to pair your headset with
your mobile phone:
• Manual pairing
• NFC pairing
Manual pairing
1
Make sure that the headset is fully charged
and turned off.
2
Press and hold the call/music button until
the blue and white LED flashes alternately.
» The headset remains in pairing mode
for 2 minutes.
3
Make sure that the mobile phone is turned
on and its Bluetooth feature is activated.
4
Pair the headset with the mobile phone.
For detailed information, refer to the user
manual of your mobile phone.
NFC pairing
1
Make sure that the mobile phone is turned
on.
2
Make sure that the headset is fully charged
and turned off.
3
Press and hold the call/music button until
the blue and white LED flashes alternately.
4
Make sure you turn on the NFC function
on your phone and your phone's screen
remains active.
5
Place your phone over the headset so that
the NFC detection area of each device can
touch each other.
6
Follow the pairing instructions of your
phone. Enter the password "0000" (4
zeros) if prompted.
EN
5