Table of Contents
Advertisement
3 Get started
Charge the headset
Warning
•
Before you use your headset for the first time, charge the battery for
four hours for optimum battery capacity and lifetime.
•
Use only the original USB charging cable to avoid any damage.
•
Finish your call before charging the headset, as connecting the headset
for charging will power off the unit.
•
You can operate the headset normally during charge.
1
Remove the USB cap.
2
Plug the headset into a powered USB port with USB charging
cable.
LED turns red during charge and turns off when the headset
»
is fully charged.
Tip
•
Typically, a full charge takes two hours.
EN
6
Pair the headset with your mobile phone
Before you use the headset with a mobile phone for the first time,
pair it with the mobile phone. A successful pairing establishes a
unique encrypted link between the headset and the mobile phone.
The headset stores the last three links in the memory. If you try to
pair more than three devices, the link for the earliest paired device is
overwritten.
1
Ensure that the mobile phone is turned on and its Bluetooth
feature is activated.
2
Ensure that the headset is charged and turned off.
3
Press
until the LED starts flashing red and blue alternately.
Do not stop pressing the button after seeing the blue LED
only.
»
The headset is in pairing mode, which lasts five minutes.
4
Pair the headset with the mobile phone. For details, refer to
the user manual of the mobile phone.
A sample pairing is shown below.
1
Under Bluetooth menu on the mobile phone, search for the
headset.
2
On mobile phones using Bluetooth 2.1 or higher, you do not
need to enter a pass code.
3
From the found devices, select Philips SHB6000.
0000" (4 zeros), if prompted to enter the pin code
•
Enter "
of the headset.
10:35
Settings
Connectivity
Settings
Devices Found
Bluetooth
Philips SHB6000
Add
Bluetooth
device
Select
Select
Back
10:36
10:37
Settings
Connectivity
Enter Password
****
0000
Select
Back
Back
Advertisement
Table of Contents
