Wall-Mounting - Targa LCD-Display 19" User Manual

Wall-Mounting

You can mount your LCD 19-6 Wide to the wall by using a VESA
wall mount with a 100 x 100 mm receptacle. To do so, disassemble
the base as follows:
1. Power the device off and unplug all cables and connectors.
For the following steps you'll need a conventional Philips
screwdriver.
2. Lie a soft cloth on an empty, level table and carefully place
the LCD 19-6 Wide with its front on it.
3. Loosen the monitor socket by carefully pushing the six
hooks inwards and pulling the socket towards the bottom.
4. Loosen the six screws located inside the base. Next you can
pull the base off downwards. You can remove the copper
loop as well as the cable contained in the base together with
the base.
5. Install the VESA wall mount on the back of the monitor.
Follow the installation instructions that came with your wall
mount kit.
Note: Keep the base, the socket and the screws in a safe place in
case you need to reassemble the base again.
Targa Visionary LCD 19-6 Wide
17