Hitachi 26LD9000TA User Manual page 38

TROUBLESHOOTING(continued)
Symptom and Check List (continued)
Symptom
No picture
The Indicating lamp → Off
No picture
The Indicating lamp → Orange
It means that the unit is in "Power Save
mode".
No picture
The indicating lamp → Green
The top of the television and surface of
the panel heat up.
Image cannot be displayed in the correct
position.
When the VCR is in special playback
features (Fast forward or Rewind), the
screen gets dark and cannot see the
image at all.
Screen display size cannot be switched
correctly.
Cannot be displayed the image from HDM.
Check list
Check if the Power Cord is plugged into the socket firmly.
Check if the Main Power is ON.
Check if all the cables of the external equipments are connected
correctly and firmly.
Check if the power of the external equipments is ON.
Check if the TV/AV mode has been selected correctly.
Check if the PC is in Power Save mode or not.
Refer to "Power Save mode" and "When following messages appears
on the screen"
Check if the signal cable is connected correctly and firmly.
Adjust the level of Brightness and Contrast lower.
It may happen when you use the unit for long hours. Turn off the Main
Power of the unit for a while. Please note that this is not malfunction.
Press button to check if the input signal of the displayed image is
compatible with the specification of the television.
It could happen when the VCR is connected to Component output,
such as 480i. This is not malfunction.
Try Composite output or S-video output and check the picture again.
The display size is fixed at "FULL" when the receiving signals are
1080i/60Hz, 1080i/50Hz, 720p/60Hz, or 720p/50Hz.
Check the signal status by pressing the
control.
Check if the cables are connected correctly.
Check the output format of the equipments.
(Please refer to "Connecting Procedure" and "Recommended Signal
List".)
Page
14 , 19
35
14 ~ 18
39 , 41
39 , 41
32 , 33
button on the remote
17 ~ 41
37