Resetting the unit
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ball-point
Pressing the RESET button will erase the clock setting
and some stored contents.
Preparing the card remote
Before using the card remote commander for the
first time, remove the insulation film.
For how to replace the battery, see "Maintenance" on
Setting the clock
The clock uses a 12-hour digital indication.
Press and hold the select button.
The setup display appears.
Press the select button repeatedly
until "CLOCK-ADJ" appears.
Press (SEEK) +.
The hour indication flashes.
Rotate the control dial to set the hour
To move the digital indication, press (SEEK)
Press the select button.
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press
(DSPL) again to return to the previous display.
Adjusting the volume level of
When connecting to a portable audio device via
Bluetooth connection or AUX input jack, we
recommend adjusting the volume level of the
connected device, or adjusting the volume level
for each connected device in the setup menu on
this unit. For Bluetooth device, see "Adjusting
the volume level" on page 16. For a device
connected to AUX, see "Adjust the volume level"
on page 19.
Detaching the front panel
You can detach the front panel of this unit to
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
The unit is turned off.
, then pull it off towards you.
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.