Dell Inspiron 1150 Service Manual page 44

Microprocessor Thermal-Cooling Assembly: Dell Inspiron 1150 Service Manual
1 captive screws (4)
2 fan power-cable connector
6. Pull up the microprocessor thermal-cooling assembly by the pull-tab to lift the assembly out of
the system board.
Installing the Microprocessor Thermal-Cooling Assembly
NOTICE: Before you install the replacement microprocessor thermal-cooling assembly, remove
the mylar that covers the thermal grease on the assembly.
1. If you are installing a replacement microprocessor thermal-cooling assembly, remove the mylar
that covers the thermal grease on the assembly. If you are installing the assembly that you
removed in the previous section:
a. Wipe the thermal grease off of the microprocessor thermal-cooling assembly with a clean
paper towel.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LAP...hecked%20ok/Inspiron/1150/1150%20SM/thermal.htm (2 of 3)6/21/2004 12:41:08 AM