Warranty - scope Connexions CX9DC Installation & User Manual

ConneXions CX9DC DC power, Two Port Version
Preface
Installation
Installation must only be undertaken by an Approved contractor, who shall ensure that all work is
carried out in compliance with National Wiring Regulations. For mains powered equipment, a readily
accessible isolating fuse or switched socket must be located within 1 metre of the equipment.
No User Serviceable Parts
Alteration or modification to any part of this equipment, without the prior written consent of the
manufacturer, will invalidate all Approvals and Warranties attaching to the equipment. Further liability
for the operation of the equipment, under the applicable law, will pass to the user, who will absolve the
manufacturer of any further responsibility for it's correct operation and use.
Liability
Scope does not accept liability for any damage or injury, howsoever caused as the result of misuse of
this equipment. It is the responsibility of the user to ensure that the equipment is operated in the
manner for which it was intended and that it is the correct item of equipment for the required task.

Warranty

This product is warranted as free from defects of workmanship and materials for a period of one year
from the original purchase date. During this time, if there is a defect or malfunction of this product,
Scope will, with proof of purchase, repair or replace at it's discretion any defective parts, free of
charge. This does not include where the adjustments, parts and repair are necessary due to
circumstances beyond the control of Scope, including but not limited to fire or other casualty, accident,
neglect, abuse, abnormal use or battery leakage damage.
WARNING! No User Serviceable Parts
Alteration or modification to any part of this equipment, without the prior written consent of the
manufacturer, will invalidate all manufacturer approvals and warranties. No adjustments can be
undertaken except by qualified and licensed persons as authorised by Scope.
This product complies with the essential requirements of the R&TTE Directive 1999/5/EC
Copies of the Declaration of Conformity covering this product can be obtained from Scope at:
Quantum House, Steamer Quay, Totnes TQ9 5AL United Kingdom.
Do not discard. At end of life this equipment must be sent to an authorised waste treatment centre.
Contact Scope at the above address for further details.
© Scope Communications UK Ltd, 2008 All Rights Reserved. E & OE.
CX9DC Issue 1
Page 2 of 13