Reassembly Precedure For Mechanism Unit - Citizen CBM1000 Service Manual

3.3.2 Reassembly Procedure for Mechanism Unit
(1) Assembling Auto Cutter SA
• Insert safety cover over cutter plate through
the slots (indicated by two upward arrows)
into the mating slots.
• Attach EXT spring-03 as shown.
• Attach auto cutter in between cutter plate and
safety cover in the direction of the arrow and
secure it with two screws (M3 × 6 (ST)).
(Use hole A for the partial-cut type, and hole
B for the full-cut type.)
(2) Assembling Center Frame SA
• Set one end of sensor PCB assy in the holder
and secure the other end to center frame with
a screw (M2.6 × 8 (BT)) as shown.
• Attach slider to DIP switch cover.
• Install DIP switch cover, guide roller, sensor
plate, and PNE lever assy.
Grease both ends of guide roller shaft.
Auto cutter
M3 × 6 (ST)
Safety cover
Sensor plate
PNE lever assy
9
CBM1000 TYPE II Service Manual
Cutter Plate
EXT spring-03
Slider
DIP switch cover
Center frame
Guide roller
M2.6 × 6 (BT)
Sensor PCB assy