Honda CB600F 2004 Owner's Manual page 141

Drive Chain
RIGHT SIDE
(3)
(2)
(1) axle nut
(2) lock nut
(3) drive chain
adjusting nut
1. Place the motorcycle on its side stand
with the transmission in neutral and the
ignition switch OFF.
2. Loosen the axle nut ( ).
132
Servicing Your Honda
(5) (4)
(1)
(3) index marks
(4) index lines
1
3. Loosen the lock nuts ( ) on both sides
of the swingarm.
4. Turn both adjusting bolts ( ) an equal
number of turns until the correct drive
chain slack is obtained. Turn the
adjusting bolts counterclockwise to
tighten the chain, or clockwise to
provide more slack. Adjust the chain
slack at a point midway between the
drive sprocket and the rear wheel
sprocket.
Roll the motorcycle forward. Stop and
place it on its side stand. Recheck chain
slack. Chain slack should allow the
following vertical movement by hand:
1 3/16 1 9/16 in (30 40 mm)
2
3