Table of Contents
Advertisement
Peripheral Configuration
Peripheral Configuration
Serial Port A
Base I/O address/IRQ
Serial Port B
Base I/O address/IRQ
Parallel Port
Mode
Base I/O addreee
DMA Channel
Floppy disk connector
Floppy check
Parallel ATA
Serial ATA
Native Mode Operation
F1: Help
: Select Item
Esc: Exit
: Select Menu
Serial Port A
This allows users to configure serial prot A by using this option.
Disabled
Disable the configuration.
Enabled
Enable the configuration (Default value)
Base I/O Address/IRQ
3F8/IRQ4
Set IO address to 3F8. (Default value)
2F8/IRQ3
Set IO address to 2F8.
3E8/IRQ4
Set IO address to 3E8.
2E8/IRQ3
Set IO address to 2E8.
PhoenixBIOS Setup Utility
[Enabled]
[3F8/IRQ4]
[Enabled]
[2F8/IRQ3]
[Enabled]
[Bi-directional]
[378]
[DMA3]
[Disabld]
[Disabld]
[Both]
[Enabled]
[Auto]
+ -: Change Values
Enter: Select
Sub-Menu
Figure 2-4: Peripheral Configuration
4 3
BIOS Setup
Item Specific Help
F5: Setup Defaults
F10: Save&Exit
Advertisement
Table of Contents
