Canceling The Demo Mode; Setting The Clock; Detaching The Front Panel - Sony MEX-BT4050U Operating Instructions Manual

100 kHz (FM)/10 kHz (AM) step, set the
tuning step before use.
This setting appears when this unit is turned
off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "TUNER-
STP" appears, then press it.
3
Rotate the control dial to select from
"50K/9K," "100K/10K" or "200K/10K,"
then press it.
Receivable frequency by selected frequency
setup:
FM 50 kHz: 87.50 MHz, 87.55 MHz, 87.60
MHz...
FM 100 kHz: 87.5 MHz, 87.6 MHz, 87.7
MHz...
FM 200 kHz: 87.5 MHz, 87.7 MHz, 87.9
MHz...
AM 9 kHz: 531 kHz, 540 kHz, 549 kHz...
AM 10 kHz: 530 kHz, 540 kHz, 550 kHz...
Canceling the DEMO
mode
You can cancel the demonstration display
which appears while this unit is turned off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "DEMO"
appears, then press it.
3
Rotate the control dial to select
"DEMO-OFF," then press it.
The setting is complete.
4
Press (BACK).
The display returns to normal reception/
play mode.
6

Setting the clock

The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "CLOCK-
ADJ" appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
 –/+.
4
After setting the minute, press the
select button.
The setup is complete and the clock
starts.
To display the clock, press .

Detaching the front panel

You can detach the front panel of this unit
to prevent theft.
Press and hold  .
1
The unit is turned off.
2 Press the front panel release button ,
then remove the panel by pulling it
towards you.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.