Presetting Stations Manually; Presetting Stations Automatically; Tuning To Preset Stations; Frequency Search Function - Alpine CDA-9886 Owner's Manual

01GB00CDA9886.book Page 8 Friday, September 28, 2007 10:20 AM

Presetting Stations Manually

1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Press and hold, for at least 2 seconds, any one of the
preset buttons (1 through 6) into which you wish
to store the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
• A total of 18 stations can be stored in the preset memory (6 stations
for each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.

Presetting Stations Automatically

1
Press BAND repeatedly until the desired radio band
is displayed.
2
Press and hold TUNE/A.ME for at least 2 seconds.
The tuner will automatically seek and store 6 strong stations
in the selected band. They will be stored into preset buttons
1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
• If no stations are stored, the tuner will return to the original station
you were listening to before the auto memory procedure began.

Tuning to Preset Stations

1
Press BAND repeatedly until the desired band is
displayed.
2
Press any one of the station preset buttons
(1 through 6) that has your desired radio station in
memory.
The display shows the band, preset number and frequency
of the station selected.

Frequency Search Function

You can search for a radio station by its frequency.
1
Press and hold /ENT for at least 2 seconds in
Radio mode to activate Frequency search mode.
2
Turn the Rotary encoder to select the desired
frequency.
3
Press /ENT to receive the selected frequency.
• Press and hold /ESC for at least 2 seconds in the search mode to
cancel. Or, the search mode will be canceled if no operation is
performed for 10 seconds.
8
-EN
01GB05CDA9886.fm

CD/MP3/WMA/AAC

Rotary encoder
SOURCE/
/ENT
(OPEN)
/
VIEW F/SETUP

Playback

1
Press (OPEN).
The front panel will open.
2
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Close the front panel manually.
When a disc is already inserted, press SOURCE/
switch to the DISC mode.
TUNER DISC USB iPod*
3
Bluetooth Audio* CHANGER*
1
* Displayed only when the iPod is connected and AUX+ Setup is set to
OFF, refer to "Setting the AUX+ Setup Mode" (page 18).
2
* Displayed only when the AUX+ Setup is set to ON, refer to "Setting
the AUX+ Setup Mode" (page 18).
3
* Displayed only when Bluetooth IN is set to ADAPTER, refer to
"Bluetooth Setting" (page 17).
4
* Only when the CD changer is connected.
3
While playing back MP3/WMA/AAC, press
select the desired folder.
Pressing and holding or
continuously.
ALPINE CDA-9886 68-09359Z43-A (EN)
/ESC
4 5
to
1 2
/AUX+*
4
TUNER
or to
will change folders