Celsius CELCV200 Operating Instructions page 3

OPERATING YOUR HEATER
Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all
packaging has been removed form the unit before use. This appliance requires no installation, it should be
used solely as a portable appliance.
PLEASE NOTE: As this product is fitted with a timer, the timer has been set to the "ON" position.
Please refer to the timer section for setting instructions.
ASSEMBLING YOUR HEATER
Before using the heater the feet (supplied separately in the carton), must be fitted to the unit. These are to
be attached to the base of the heater by placing the lugs on the feet in the bottom ends of the heater side
mouldings. The screw pack to attach the feet to your heater will be taped to either one of the feet for your
heater, or taped to the plug head.
HEAT CONTROL
The control switch positions are:
O Off
I Low Heat
II Medium Heat
III High Heat
Check that the Heat Control Dial is in the Off position before plugging the heater into the mains supply. For
greater economy, use the High Heat setting initially and then switch to the Lower Heat settings.
THERMOSTAT
Turn the thermostat knob clockwise until you reach the maximum temperature on the graduated scale.
When the desired room temperature is reached, slowly turn the knob anti-clockwise until the heater turns off
(you will hear a click). The heater will now cycle on and off to maintain the set temperature.
FAN BOOST
Additional to the three heat settings there is a fan with a separate On/Off switch located on the control panel.
The fan function is for distributing heat into the room at a faster rate.
SAFETY DEVICE
This appliance has two protection devices. The first device, automatically disconnects & reconnects the
appliance at a pre-set temperature. The second safety device disconnects the appliance permanently in
case of overheating, by means of a thermal fuse (it is non resettable).
Do not attempt to dismantle the heater. There are no user serviceable parts. For service or repair, contact
an authorised electrical service technician.
IMPORTANT! NEVER COVER THIS HEATER!