Program Mode - Hyundai H-1416 Instruction Manual

button on the RC to start playback, the LCD
display will show the first track.
• Press PLAY/PAUSE/BAND (AM/FM) button
on the unit or BAND/PLAY/PAUSE button on the
RC to pause at any track when playing, track
number on the LCD display flashes.
• To stop playback, press STOP/CD/USB/
FM MODE button on the unit or STOP/FM
MODE button on the RC.
Skip and search mode
• Press the NEXT/TUNE UP button once
to skip to the next track. Press and hold this
button to search for a particular point at high
speed forward. Release the button to resume
normal play.
• Press the BACK/TUNE DOWN button
once to skip back to previous track. Press and
hold this button to search for a particular point
at high speed backward. Release the button
resume normal play.
Repeat mode
• Press REPEAT/PROGRAM/MEMORY
button on the unit or PLAY MODE/MEMORY
BUTTON on the RC once for single track
repeat playing.
• Press twice for all track repeat playing.
• To cancel repeat play, press REPEAT/
PROGRAM/MEMORY button on the unit or
PLAY MODE/MEMORY BUTTON on the RC
again.

Program mode

Up to 60 tracks can be programmed for disc
play in any order or the same track can be
repeated up to 60 times.
• Before use, be sure to stop the CD by
pressing STOP/CD/USB/FM MODE button on
the unit or STOP/FM MODE button on the RC.
• Press REPEAT/PROGRAM/MEMORY
button on the unit or PLAY MODE/MEMORY
button on the RC. The display will show "P01"
and "PROG" symbol. This indicates that the set
is now in memory programming mode, at the
first memory position.
• Select a desired track by using the BACK/
Instruction manual
TUNE DOWN and NEXT/TUNE UP buttons.
• Press REPEAT/PROGRAM/MEMORY
button on the unit or PLAY MODE/MEMORY
BUTTON on the RC again to confirm. The
set will advance to next memory position,
the display will show "P02". Repeat steps
described above to enter additional memories
into the program if necessary.
• After a maximum of 60 songs (or less)
have been selected as described above, press
PLAY/PAUSE/BAND (AM/FM) button on the
unit or BAND/PLAY/PAUSE button on the RC
to start playing the programmed tracks.
• The "PROG" symbol will remain to indicate
that you have saved a program-memory
(sequence).
• The program memory will be cleared when
you press STOP/CD/USB/FM MODE button on
the unit or STOP/FM MODE button on the RC
or turn off the CD or power supply.
MP3 operation
• Set FUNCTION switch to USB/SD/CD
position.
• Open the CD door. Put a MP3 disk into the
CD compartment and close the CD door.
• The disk will spin and perform a full check
of the disc to count the total number of songs.
Then playback of the first song (track) will
begin and the display will indicate the current
track number.
• If your disc has folders, the display will show
the folder number (e.g. F01) every 5 seconds.
• At any time during playback, press and
release BACK/TUNE DOWN or NEXT/TUNE
UP buttons to skip backwards or forwards by
one track.
• If your MP3 disc has no folders, you can
use SKIP +10/FOLDER/MEM SET button to
jump 10 songs ahead.
• Press SKIP +10/FOLDER/MEM SET several
times until you reach a song number near to
your desired song, and then press BACK/TUNE
DOWN or NEXT/TUNE UP repeatedly to arrive
and the exact song you desire.
• If your MP3 disc has folders, you can
select the folder to playback. Press and hold
5