Using The Remote Control Unit; How To Install Batteries - Sanyo SAP-KRV96EH Technical & Service Manual

USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES

ACL button
1.
Slide the cover in the direction indicated by the arrow and
remove it.
2.
Install two AAA alkaline batteries. Make sure the batteries point
in the direction marked in the battery compartment.
3.
Use a thin object such as the tip of a pen to press the ACL
button.
NOTE
• The batteries last about six months, depending on how
much you use the remote control unit. Replace the
batteries when the remote control unit's display fails to
light, or when the remote control cannot be used to change
the air conditioner's settings.
• Use two fresh leak-proof type-AAA alkaline batteries.
• In replacing batteries, follow the instructions as mentioned
in the sub-section "HOW TO INSTALL BATTERIES".
• If you do not use the remote control unit more than 1
month, take out the batteries.
HOW TO USE THE REMOTE CONTROL UNIT
When using the remote control unit, always point the unit's
transmitter head directly at the air conditioner's receiver.
Air conditioner
(Indoor unit)
Remote control
unit
8
REMOTE CONTROL UNIT INSTALLATION
POSITION
The remote control unit may be operated either from a non-fixed
position or from a wall-mounted position. To ensure that the air
conditioner operates correctly, DO NOT install the remote control
unit in the following places:
DO NOT
• In direct sunlight
• Behind a curtain or other places where it is covered
• More than 8 m away from the air conditioner
• In the path of the air conditioner's airstream
• Where it may become extremely hot or cold
• Where it may be subject to electrical or magnetic noise
• Where there is an obstacle between the remote control unit and
MOUNTING THE REMOTE CONTROL UNIT
Before mounting the remote control unit, press the ON/OFF
operation button at the mounting location to make sure that the air
conditioner operates from that location. The indoor unit should
make a beeping sound to indicate that it has received the signal.
To take out the remote control unit, pull it forward.
WHEN HOLDING THE REMOTE CONTROL UNIT
• When using the remote control unit and during air conditioner
• Make sure that there are no objects between the remote control
Receiver
(Transmitter head)
air conditioner (since a check signal is sent from the remote
control unit every 5 minutes)
Remote control unit mount
Press
Set in
place
• To prevent loss of the remote control
Mounting screws
unit, you can connect the remote
4 x 16 (included)
control unit to the mount by passing
a string through the remote control
unit and attachment hole.
operation, the transmitter on the remote control unit should be
pointed toward the receiver on the indoor unit.
unit and receiver which could block the signal.
Rear side
Hole
OI-002-8-EG