JVC LT-26DX7BGE Instructions Manual page 29

Troubleshooting
Problem
Wrong screen size
No picture, no sound
No sound
Green and distorted
screen
Some inputs cannot
be selected in the
sub-picture
"Feature Not Available"
"ACI Error"
"No Recording"
" No Recording
Possible"
" No Recording Media
Problem"
" No Recording Device
Busy"
53
(continued)
Actions
 Switch "Size" in "HDMI Setting" to "1" or "2".
Use the cable marked with HDMI logo.

Check if the device is compliant with HDMI.

 Switch "Audio" in "HDMI Setting" to "Digital" or "Auto" for
HDMI devices, or "Analogue" or "Auto" for DVI devices.
(Not available for "EXT-6".)
Wait a little for the signal to stabilize when switching the

signal format for an "HDMI" device.
Digital channels, EXT-4, EXT-5, EXT-6 inputs, and PC mode

cannot be selected in the sub-picture.
RGB input signal of EXT-1 and EXT-2 are not available in

dual-picture mode.
Is the T-V LINK compatible device connected to EXT-2?

Is the SCART CABLE "Fully Wired"?

Is the T-V LINK compatible device turned on?

After confirming all the conditions above,
press "OK" button again.
Press 2 to start ACI again.

If you still receive the "ACI Error" after numerous tries,
press 3 to cancel ACI.
A problem occurs at the recorder.

The displayed video cannot be recorded.

The recorder is not ready for recording.

Check the videotape or DVD disc.
The recorder is recording another programme, or is playing.

page Problem
36
Black or white dots
appear on the screen
–
–
36
– "Dolby Digital selected!
No analogue audio
available"
–
56
56
–
Forgot my PIN code!
–
Locked channels can
–
be watched without
inputting PIN code
–
–
When JVC or the
broadcasting station
informs you of the
software
–
Actions
LCD panels use fine dots ("pixels") to display images.

While more than 99.99% of these pixels function properly,
a very small number of pixels may not light, or may light all
the time.
Please understand that this is not a malfunction.
When "Dolby Digital" is selected in "Digital Audio Output", the
sound of a programme containing "Dolby Digital" signals cannot
be output from the TV or the audio system connected to the
"AUDIO OUT" terminal.
When the channel is changed, a message will be displayed for
a few seconds.
To listen with the TV or audio system

 Select a language without "(Dolby)" from "Audio Selection"
 Switch "Digital Audio Output" to "PCM"
 The default PIN code is "0000". If you forget the numbers that
you used to change the default PIN code, first input "0081" in
the "Enter PIN code" and then register a new PIN code.
Once the PIN code is input, all the lock functions ("Lock" and

"Maturity Rating") are released. If you want to use the lock
function again, turn the TV off and then turn it on again.
 Upgrade the tuner software by using the "Receiver Upgrade"
function.
page
–
57
29
43
41
–
43
54