Page 2
Items Contents Dimensions ( W × H × D ) 66.0 cm × 48.25 cm × 20.0 cm [66.0 cm × 44.0 cm × 9.0 cm (Without stand)] Mass 9.5 kg [8.0 kg (Without stand)] Power Input AC220V - AC240 V, 50 Hz Power Consumption 95 W (Standby: 0.8 W) TV RF System...
SECTION 1 PRECAUTION SAFETY PRECAUTIONS (1) The design of this product contains special hardware, (6) Isolation Check (Safety for Electrical Shock Hazard) many circuits and components specially for safety After re-assembling the product, always perform an isola- purposes. For continued protection, no changes should be tion check on the exposed metal parts of the cabinet (an- made to the original design unless authorized in writing by tenna terminals, video/audio input and output terminals,...
Page 4
INSTALLATION 1.2.1 HEAT DISSIPATION 1.2.3 INSTALLATION REQUIREMENTS If the heat dissipation vent behind this unit is blocked, cooling Ensure that the minimal distance is maintained, as specified efficiency may deteriorate and temperature inside the unit will below, between the unit with and the surrounding walls, as well rise.
Page 5
HANDLING LCD PANEL 1.3.2 OPTICAL FILTER (ON THE FRONT OF THE LCD PANEL) (1) Avoid placing the unit under direct sunlight over a 1.3.1 PRECAUTIONS FOR TRANSPORTATION prolonged period of time. This may cause the optical filter When transporting the unit, pressure exerted on the internal LCD to deteriorate in quality and COLOUR.
SECTION 2 SPECIFIC SERVICE INSTRUCTIONS FEATURES DIGITAL TUNER PICTURE MODE This TV can receive both DVB-T (Digital terrestrial broadcasting), This function can adjust the picture settings automatically. DVB-S(Digital satellite broadcasting), and Analogue terrestrial There are BRIGHT, STANDARD, SOFT and MANUAL in the broadcasting.
Page 7
TECHNICAL INFORMATION 2.3.1 LCD PANEL This unit uses the flat type panel LCD (Liquid Crystal Display) panel that occupies as little space as possible, instead of the conventional CRT (Cathode Ray Tube), as a display unit. Since the unit has the two polarizing filter that are at right angles to each other, the unit adopts "normally black" mode, where light does not pass through the polarizing filter and the screen is black when no voltage is applied to the liquid crystals.
SECTION 3 DISASSEMBLY CAUTION AT DISASSEMBLY • Make sure that the power cord is disconnected from the outlet. • Pay special attention not to break or damage the parts. • Make sure that there is no bent or stain on the connectors before inserting, and firmly insert the connectors. •...
Page 9
SIDE SHIELD REAR COVER POWER UNIT POWER MAIN PWB BRACKET MAIN SHIELD INVERTER PWB COVER PANEL BRACKET STAND LCD PANEL PANEL INVERTER BRACKET BLUE LED MODULE SPEAKER IR PWB CONTROL KNOB SPEAKER FRONT KEY PWB CONTROL CABINET BASE Fig.3-1 (No.YA698<Rev.001>)1-9...
Page 10
MEMORY IC REPLACEMENT • This model uses the memory IC. • This memory IC stores data for proper operation of the video and drive circuits. • When replacing, be sure to use an IC containing this (initial value) data. 3.3.1 MEMORY IC REPLACEMENT PROCEDURE 1.
Page 11
3.3.3 SETTINGS OF FACTORY SHIPMENT 3.3.3.1 BUTTON OPERATION 3.3.3.2 REMOTE CONTROL DIRECT OPERATION Setting item Setting position Setting item Setting position POWER CHANNEL CHANNEL VOLUME VOLUME ZOOM AUTO SUB POWER 3.3.3.3 REMOTE CONTROL MENU OPERATION (1) Picture (4) Feature Setting item Setting position Setting item Setting position...
Page 12
REPLACEMENT OF CHIP COMPONENT 3.4.1 CAUTIONS (1) Avoid heating for more than 3 seconds. (2) Do not rub the electrodes and the resist parts of the pattern. (3) When removing a chip part, melt the solder adequately. (4) Do not reuse a chip part after removing it. 3.4.2 SOLDERING IRON (1) Use a high insulation soldering iron with a thin pointed end of it.
SECTION 4 ADJUSTMENT ADJUSTMENT PREPARATION (1) This TV is adjusted by using REMOTE CONTROL UNIT. (2) The adjustment using the REMOTE CONTROL UNIT is made on the basis of the initial setting values. The setting values which adjust the screen to the optimum condition can be different from the initial setting values. (3) Make sure that connection is correctly made AC to AC power source.
ADJUSTMENT PROCEDURE 4.7.1 VIDEO CIRCUIT Measuring Item Test point Adjustment part Description instrument WHITE Remote [White Balance] (1) Set COLOUR TEMP. to "Normal". BALANCE control unit Normal R (2) Enter the FACTRY MODE. Normal G (3) Press [ ] / [ ] key on the remote control unit Signal Normal B simultaneously to select the White balance.
PARTS LIST CAUTION The parts identified by the symbol are important for the safety . Whenever replacing these parts, be sure to use specified ones to secure the safety. The parts not indicated in this Parts List and those which are filled with lines --- in the Parts No. columns will not be supplied. P.W.
Page 16
IR P.W. BOARD ASS'Y (HU-72200001) ......................3-11 KEY P.W. BOARD ASS'Y (HU-72200002) ...................... 3-11 PACKING ................................... 3-12 PACKING PARTS LIST ............................. 3-12 USING P.W. BOARD & REMOTE CONTROL UNIT P.W.B ASS'Y No. P.W.B ASS'Y name LT-26DB1BU/AX MAIN P.W.B HU-71100005 IR P.W.B HU-72200001 KEY P.W.B HU-72200002...
PRINTED WIRING BOARD PARTS LIST MAIN P.W. BOARD ASS'Y (HU-71100005) Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local D521 HU-003041002 SI DIODE D522 HU-003041002 SI DIODE HU-000140583 DC-DC CONV D523 HU-003041002 SI DIODE HU-000091030 LDO REGULATOR D524...
Page 19
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C166 HU-001060297 C CAPACITOR 0.01pF 50V K C337 HU-001060250 C CAPACITOR 0.1uF 16V K C181 HU-001060250 C CAPACITOR 0.1uF 16V K C338 HU-001060250 C CAPACITOR 0.1uF 16V K C182 HU-001060286...
Page 20
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C446 HU-001060250 C CAPACITOR 0.1uF 16V K C623 HU-001060309 C CAPACITOR 10uF 16V K C447 HU-001060286 C CAPACITOR 10uF 10V C624 HU-001060250 C CAPACITOR 0.1uF 16V K C449 HU-001060250...
Page 21
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C833 HU-001060309 C CAPACITOR 10uF 16V K C1102 HU-001060286 C CAPACITOR 10uF 10V C834 HU-001060318 C CAPACITOR 0.1uF 50V C1200 HU-001060309 C CAPACITOR 10uF 16V K C835 HU-001060318 C CAPACITOR...
Page 22
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R179 HU-002000433 MG RESISTOR 0Ω R403 HU-002001141 MG RESISTOR 57.6Ω R182 HU-002000437 MG RESISTOR 10kΩ R404 HU-002001007 MG RESISTOR 1.8kΩ R183 HU-002000417 MG RESISTOR 4.7kΩ...
Page 23
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R575 HU-002000433 MG RESISTOR 0Ω R755 HU-002001060 MG RESISTOR 220kΩ R577 HU-002000433 MG RESISTOR 0Ω R757 HU-002001060 MG RESISTOR 220kΩ R579 HU-002000438 MG RESISTOR 12kΩ...
Page 24
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R964 HU-002000527 MG RESISTOR 100Ω L703 NQR0154-002X FERRITE CORE R966 HU-002000527 MG RESISTOR 100Ω L704 NQL812K-1R8X PEAKING COIL 1.8uH K R967 HU-002000433 MG RESISTOR 0Ω...
PACKING 13 18 PACKING PARTS LIST Ref.No. Part No. Part Name Description Local ------------ CARTON BOX Not supply ------------ CUSHION Not supply HU-0320200064 REMOTE CONTROL UNIT RM-C2503 ------------ BATTERY AAA/R03(x2) HU-2000000111 INST BOOK English/French/German/Italian ------------ WARRANTY CARD HU-2030000021 HU-2000700105 CAUTION SHEET ------------...
Page 28
LT-26DB1BU STANDARD CIRCUIT DIAGRAM NOTE ON USING CIRCUIT DIAGRAMS 1.SAFETY Type No indication : Ceramic capacitor The components identified by the symbol and shading are : Metalized mylar capacitor critical for safety. For continued safety replace safety ciritical : Polypropylene capacitor components only with manufactures recommended parts.
Page 29
KEY PWB CIRCUIT DIAGRAM ......................... 2-65 PATTERN DIAGRAMS ................2-67 MAIN PWB PATTERN ..........................2-67 IR PWB PATTERN ............................ 2-71 KEY PWB PATTERN ..........................2-71 USING P.W. BOARD P.W.B ASS Y name LT-26DB1BU/AX MAIN P.W. BOARD HU-71100005 IR P.W. BOARD HU-72200001 KEY P.W. BOARD HU-72200002...
WIRING DIAGRAM LCD PANEL UNIT [LCD CONTROL PWB] LCD PANEL UNIT [INVERTER PWB] JP451 DIGITAL TUNER (SATELLITE) KEY PWB DIGITAL TUNER (TERRESTRIAL) JP761 MAIN PWB 250V/6.3A POWER UNIT SPEAKER(L) SPEAKER(R) AC INLET BLUE LED MODULE IR PWB (No.YA698<Rev.001>)2-3 2-4(No.YA698<Rev.001>)
Page 55
MAIN PWB CIRCUIT DIAGRAM (24/28) [TS Switch] TS0_DATA from TER DTT ONLY MODEL OPTION MAIN PWB (26/28) TS0_DATA[7..0] U851 SN74LVC244APWR TS0_DATA0 TSI_D0 R851 101/1005 101/1005 MUX_TSI_D0 TS0_DATA0 PR851 TSI_D0 MUX_TSI_D0 TS0_DATA1 TSI_D1 R852 101/1005 101/1005 MUX_TSI_D1 TS0_DATA1 OPEN-000*4/1005 TSI_D1 MUX_TSI_D1 TS0_DATA2 TSI_D2 R853...
Page 56
MAIN PWB CIRCUIT DIAGRAM (25/28) [CHANNEL POWER] DVB-T+C POWER QPSK POWER TP769 TP770 PCB_TP08 PCB_TP08 +3V3_TS U881 U882 LD29150PT/P-PAK 5P LD1117AL-ADJ MAX 1.5A C884 C888 TP765 106p/16V/2012 PCB_TP08 +5VTA 104p/16V/1005 R882 C891 C892 +5.03V MAX 490mA 121/F/1005 MAIN PWB (3/28) SMPS_ON 106p/10V/2012 104p/16V/1005...
Page 57
MAIN PWB CIRCUIT DIAGRAM (26/28) [OFDM Demodulator] +3V3DT +3V3DT R961 R962 OPEN-103/1005 472/1005 R963 102/1005 IF_AGC0 MAIN PWB +3V3DT IF_AGC0 TUNER0_AGC (1/28) JP961 CH_TER_RESET MAIN PWB (7/28) Near By Tuner OPEN-53014-0410 C975 C962 FLI_SCL0 104p/16V/1005 104p/16V/1005 FLI_SDA0 VDDD_3V3 VDDD_1V2 VDDDC_1V2 VDDA_3V3 R966 101/1005...
Page 58
MAIN PWB CIRCUIT DIAGRAM (27/28) [LNB Supply] C1085,1091,1092 are located near by U1081 C1085,1091,1092 are located near by U1081 +3V3_TS C1082 104p/50V/2012 R1081 C1081 103p/50V C1083 D1081 OPEN-222/1005 104p/50V/2012 SS14 R1083 220/1005 22K_TONE MAIN PWB (28/28) D1082 C1085 C1084 OPEN-SX34 474p/50V/2012 100uF/50V/NXB GND 21...
Page 65
Victor Company of Japan, Limited Display Division 12, 3-chome, Moriya-cho, Kanagawa-ku, Yokohama-city, Kanagawa-prefecture, 221-8528, Japan (No.YA698<Rev.001>) Printed in Japan...