Page 2
SPECIFICATION Contents Items LT-26DE1BJ LT-26DE1BU Dimensions ( W × H × D ) 66.0 cm × 48.83 cm × 27.86 cm [66.0 cm × 44.0 cm × 9.0 cm (Without stand)] Mass 9.2 kg [8.2 kg (Without stand)] Power Input AC220V - AC240 V, 50 Hz Power Consumption 105 W (Standby: 0.9 W)
SECTION 1 PRECAUTION SAFETY PRECAUTIONS (1) The design of this product contains special hardware, (6) Isolation Check (Safety for Electrical Shock Hazard) many circuits and components specially for safety After re-assembling the product, always perform an isola- purposes. For continued protection, no changes should be tion check on the exposed metal parts of the cabinet (an- made to the original design unless authorized in writing by tenna terminals, video/audio input and output terminals,...
Page 4
INSTALLATION 1.2.1 ATTACH THE STAND TO THE TV 1.2.4 INSTALLATION REQUIREMENTS When installing the unit on the floor, it is required to attach the Ensure that the minimal distance is maintained, as specified supplied stand. below, between the unit with and the surrounding walls, as well To attach the stand to the TV, follow the procedure below.
Page 5
HANDLING HARD DISK DRIVE (HDD) HANDLING LCD PANEL The HDD is a precision device for use in reading and writing a 1.4.1 PRECAUTIONS FOR TRANSPORTATION large amount of data on or from a disk rotating at a high speed. When transporting the unit, pressure exerted on the internal LCD If it is not handled carefully, either abnormal operation may result panel due to improper handling (such as tossing and dropping) or it may not be possible to read data.
SECTION 2 SPECIFIC SERVICE INSTRUCTIONS FEATURES DIGITAL TUNER PICTURE MODE This TV can receive both DVB-T(Digital terrestrial broadcasting) This function can adjust the picture settings automatically. and Analogue terrestrial broadcasting. There are BRIGHT, STANDARD, SOFT and MANUAL in the PICTURE MODE. HDMI INPUT By connecting a HDMI compatible device, high definition ZOOM...
Page 7
TECHNICAL INFORMATION 2.3.1 LCD PANEL This unit uses the flat type panel LCD (Liquid Crystal Display) panel that occupies as little space as possible, instead of the conventional CRT (Cathode Ray Tube), as a display unit. Since the unit has the two polarizing filter that are at right angles to each other, the unit adopts "normally black" mode, where light does not pass through the polarizing filter and the screen is black when no voltage is applied to the liquid crystals.
SECTION 3 DISASSEMBLY CAUTION AT DISASSEMBLY • Make sure that the power cord is disconnected from the outlet. • Pay special attention not to break or damage the parts. • Make sure that there is no bent or stain on the connectors before inserting, and firmly insert the connectors. •...
Page 9
SIDE SHIELD REAR COVER MAIN PWB MPEG PWB POWER UNIT POWER BRACKET HDD BRACKET INVERTER PWB COVER MAIN SHIELD PANEL BRACKET LCD PANEL STAND PANEL INVERTER BRACKET BLUE LED MODULE SPEAKER IR PWB CONTROL KNOB SPEAKER FRONT KEY PWB CONTROL CABINET BASE Fig.3-1...
Page 10
MEMORY IC REPLACEMENT • This model uses the memory IC. • This memory IC stores data for proper operation of the video and drive circuits. • When replacing, be sure to use an IC containing this (initial value) data. 3.3.1 MEMORY IC REPLACEMENT PROCEDURE 1.
Page 11
3.3.3 SETTINGS OF FACTORY SHIPMENT 3.3.3.1 BUTTON OPERATION 3.3.3.2 REMOTE CONTROL DIRECT OPERATION Setting item Setting position Setting item Setting position POWER CHANNEL CHANNEL VOLUME VOLUME ZOOM AUTO SUB POWER 3.3.3.3 REMOTE CONTROL MENU OPERATION (1) Picture (4) Feature Setting item Setting position Setting item Setting position...
Page 12
REPLACEMENT OF CHIP COMPONENT 3.4.1 CAUTIONS (1) Avoid heating for more than 3 seconds. (2) Do not rub the electrodes and the resist parts of the pattern. (3) When removing a chip part, melt the solder adequately. (4) Do not reuse a chip part after removing it. 3.4.2 SOLDERING IRON (1) Use a high insulation soldering iron with a thin pointed end of it.
SECTION 4 ADJUSTMENT ADJUSTMENT PREPARATION (1) This TV is adjusted by using REMOTE CONTROL UNIT. (2) The adjustment using the REMOTE CONTROL UNIT is made on the basis of the initial setting values. The setting values which adjust the screen to the optimum condition can be different from the initial setting values. (3) Make sure that connection is correctly made AC to AC power source.
4.5.3 CHANGE AND MEMORY OF SETTING VALUE 4.5.4 FACTORY MODE SELECT KEY LOCATION SELECTION OF SETTING ITEM • [FUNCTION / ] key. For scrolling up / down the setting items. [MUTING] key + [INFORMATION] key • [FUNCTION / ] key. For select the setting items.
Page 15
PARTS LIST CAUTION The parts identified by the symbol are important for the safety . Whenever replacing these parts, be sure to use specified ones to secure the safety. The parts not indicated in this Parts List and those which are filled with lines --- in the Parts No. columns will not be supplied. P.W.
Page 16
IR P.W. BOARD ASS'Y (HU-72200001) ......................3-11 KEY P.W. BOARD ASS'Y (HU-72200002) ...................... 3-11 PACKING ................................... 3-12 PACKING PARTS LIST ............................. 3-12 USING P.W. BOARD & REMOTE CONTROL UNIT P.W.B ASS'Y No. P.W.B ASS'Y name LT-26DE1BJ/AX LT-26DE1BU/AX MAIN P.W.B HU-71100007 ← MPEG P.W.B HU-71100010 ←...
Page 18
PRINTED WIRING BOARD PARTS LIST MAIN P.W. BOARD ASS'Y (HU-71100007) Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local HU-001060250 C CAPACITOR 0.1uF 16V K HU-001060250 C CAPACITOR 0.1uF 16V K ------------ Not supply HU-001060250 C CAPACITOR 0.1uF 16V K...
Page 19
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C233 HU-001060219 C CAPACITOR 1000pF 50V K C631 HU-001060250 C CAPACITOR 0.1uF 16V K C234 HU-001060219 C CAPACITOR 1000pF 50V K C632 HU-001060236 C CAPACITOR 10uF 25V C235 HU-001060236...
Page 20
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local HU-002000417 MG RESISTOR 4.7kΩ R356 HU-002000433 MG RESISTOR 0Ω HU-002000417 MG RESISTOR 4.7kΩ R357 HU-002000433 MG RESISTOR 0Ω HU-002000417 MG RESISTOR 4.7kΩ R370 HU-002000405 MG RESISTOR 1kΩ...
Page 21
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R669 HU-002000437 MG RESISTOR 10kΩ L378 HU-011000056 INDUCTOR 1.8uH R680 HU-002000437 MG RESISTOR 10kΩ L379 HU-011000056 INDUCTOR 1.8uH R681 HU-002000417 MG RESISTOR 4.7kΩ L380 HU-011000056 INDUCTOR 1.8uH...
Page 22
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local HU-005000900 CRYSTAL 20.25MHz C268 HU-001060250 C CAPACITOR 0.1uF 16V K Y470 HU-005000890 CRYSTAL 14.31818MHz C269 HU-001060250 C CAPACITOR 0.1uF 16V K Y800 HU-005000940 CRYSTAL 16MHz C270 HU-001060321...
Page 23
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C640 HU-001060250 C CAPACITOR 0.1uF 16V K HU-002000437 MG RESISTOR 10kΩ C641 HU-001060250 C CAPACITOR 0.1uF 16V K HU-002000437 MG RESISTOR 10kΩ C643 HU-001060265 C CAPACITOR 1uF 16V K HU-002000437...
Page 24
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R246 HU-002000433 MG RESISTOR 0Ω R760 HU-002000437 MG RESISTOR 10kΩ R312 HU-002000437 MG RESISTOR 10kΩ R811 HU-002000437 MG RESISTOR 10kΩ R320 HU-002000465 MG RESISTOR 1kΩ...
Page 25
Ref No. Part No. Part Name Description Local PR734 HU-002070039 NET RESISTOR 33Ωx4 PR735 HU-002070039 NET RESISTOR 33Ωx4 HU-005001260 CRYSTAL 27MHz Y640 HU-005000940 CRYSTAL 16MHz Y670 HU-005000940 CRYSTAL 16MHz Y760 HU-005001050 CRYSTAL 25MHz IR P.W. BOARD ASS'Y (HU-72200001) Ref No. Part No.
Page 26
PACKING 13 18 28 30 PACKING PARTS LIST Ref.No. Part No. Part Name Description Local ------------ CARTON BOX Not supply ------------ CUSHION Not supply HU-0320200008 REMOTE CONTROL UNIT RM-C2111B ------------ BATTERY AA/R6(x2) HU-2000000128 INST BOOK English LT-26DE1BJAX HU-2000000129 INST BOOK Portuguese/German/Spanish/Italian/Greek/Dutch/Czech/French LT-26DE1BUAX...
Page 28
LT-26DE1BJ , LT-26DE1BU STANDARD CIRCUIT DIAGRAM NOTE ON USING CIRCUIT DIAGRAMS 1.SAFETY Type No indication : Ceramic capacitor The components identified by the symbol and shading are : Metalized mylar capacitor critical for safety. For continued safety replace safety ciritical : Polypropylene capacitor components only with manufactures recommended parts.
Page 29
WIRING DIAGRAM LCD PANEL UNIT LCD PANEL UNIT HDD UNIT [INVERTER PWB] [LCD CONTROL PWB] DIGITAL TUNER DIGITAL TUNER JP760 KEY PWB JP850 MPEG PWB JP710 JP680 JP630 JP681 250V/6.3A POWER UNIT JP682 ANALOG TUNER AC INLET JP581 MAIN PWB IR PWB SPEAKER(L) SPEAKER(R)
Page 58
MPEG PWB CIRCUIT DIAGRAM (5/22) [STRAP] +3V3 RADD[0] Endian for main MIPS32 CPU 0 Little Endian MPEG PWB(6/22),(10/22),(12/22),(13/22) RADD[24:0] 1 Big Endian RADD0 103/1005 RADD[2:1] Merge Mode for main MIPS32 CPU OPEN-103/1005 00 No merge && ALL bytes enable 01 No merge && Simple bytes enable 10 Full merge &&...
Page 83
Victor Company of Japan, Limited Display Division 12, 3-chome, Moriya-cho, Kanagawa-ku, Yokohama-city, Kanagawa-prefecture, 221-8528, Japan (No.YA695<Rev.001>) Printed in Japan...