Listening To The Dab - Sharp XL-DAB1H Operation Manual

Listening to the radio (continued)
■
To preset a station
You can store FM stations in memory and recall them at
the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 5 seconds, press the
the preset channel number. Store the stations in
memory, in order, starting with preset channel 1.
4
Press the MEMORY button to store that station
in memory. If the "MEMORY" and preset number
indicators disappear before the station is memorised,
repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
Note:
The backup function protects the memorised stations for a
few hours should there be a power failure or the AC power
lead become disconnected.
■
To recall a preset station
Press the PRESET (
seconds to select the desired station.
■
To scan the preset station
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1
Press the PRESET (
0.5 seconds. The preset number will fl ash and the
programmed stations will be tuned in sequentially, for
5 seconds each.
2
Press the PRESET (
desired station is located.
■
To erase entire preset memory
1
Press and hold the CLEAR button until "TUN CLR"
appears then press MEMORY button.
or button to select
or ) button for less than 0.5
or ) button for more than
or ) button again when the

Listening to the DAB+

■
About DAB+ (Digital Audio Broadcasting)
Digital Audio Broadcasting is a digital transmission system
where audio signals are converted to digital signals for
broadcasting. DAB+ is broadcast as a group of data called
multiplex (ensemble) which may contain one or more
stations (services). Each station contains a primary service
and there may be one or more secondary services.
This allows several programmes or services to be
transmitted on a single frequency.
DAB+ SIGNAL
■
Auto tune
MICRO COMPONENT SYSTEM XL-DAB1
When turned on for the fi rst time, the unit scans radio
stations automatically to create a station list. You can make
the AUTOTUNE again when you move the unit to other
areas or add multiplex channels to the station list.
1
Press the TUNER/DAB button until "DAB" appears on
the display.
2
Press SCAN button on the remote control for more
than 3 seconds. AUTOTUNE scanning begins.
E-9
MULTIPLEX
(ENSEMBLE)
SERVICES
SERVICES
COMPONENTS
(STATIONS)
The scanning progress is
indicate by advancing asterisks.
The number of received station