Advertisement
(6)
When one or two MZ-80SFDs are used in conjunction with the MZ-80FBK floppy-disk drive
unit:
The MZ-80FBK (option) has two drives which have been set as drives 3 and 4; and it has not
been fitted with any terminal resistor.
Therefore, when upgrading the drive system, a maximum of two MZ-80SFDs can be used in
conjunction with the MZ-80FBK. At this time the MZ-80SFD must be fitted with a terminal
resistor.
.,
u
~
.,
...
c:
MZ-BOFBK
(Drives 3 and 4)
MZ-BOFBK
(Drives 3 and 4)
t~~~~
0'
IN
c:::::J
OUT
(Drive 1 or 2)
Set the MZ-80SFD as drive
1 or 2.
Mount the terminal resistor
on the MZ-80SFD.
Set the two MZ-
80SFDs as drives 1 and
2 .
Mount the terminal re-
sistor on drive 1.
• Never mount any ter-
minal resistor on drive
2.
[Note]
Four drive number labels, which bear numbers 1 through 4, respectively, come
with the MZ-80SFD. Glue on its front a correct label that corresponds to the drive
number setting through the drive select switch. See the figure below.
-----
abel that
Glue a correct I
agrees
with
th
number selected
the drive select s
e drive
through
witch.
--W
III
@
7
Advertisement
