Installing The Water Line - Samsung RS25H50 Series User Manual

Refrigerator
Hide thumbs Also See for RS25H50 Series:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLING THE WATER LINE

Connecting the water line to the
Refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
• 1/4" compression nut
• copper tubing
Refrigerator
Compression Nut
(1/4") (Assembled)
Ferrule
(Not supplied)
Copper tubing
(Not supplied)
Household water line
1. Tighten the compression nut ( B ) into the 1/4"
compression fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not included) and ferrule
(not included) on copper tubing (not included)
as shown.
- If you are using plastic tubing ( B ) , insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
CAUTION
Do not use without the molded end(Bulb) of the
plastic tubing ( B ).
DA68-02981E-00.indb 16
• plastic tubing
• ferrule
Plastic Tubing
(Supplied)
Compression
Fitting (Assembled)
Bulb
Compression
nut (B) (1/4")
(Not supplied)
Plastic tubing (B)
or
(Not supplied)
English - 16
2. Tighten the compression nut ( B ) into the
compression fitting. Do not over-tighten the
compression nut ( B ).
3. Turn water on and check for any leakage.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the
water line, cut off 1/4" of the plastic tubing
to make sure you get a snug, leak-free
connection.
Removing residual matter inside the water
supply line after installing filter
Ice
1. Turn ON the main water supply.
2. Press the Water button and push the dispenser
pad.
3. Flush 3 gallons of water through the filter before
use.
(Flush approximately 6 minutes.)
This will clean the water supply system and
remove air from the lines.
4. Additional flushing may be required in some
households.
5. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser.
This is due to air getting into the line. It
should pose no problem to operation.
Water
13. 12. 12.
3:07

Advertisement

Table of Contents
loading

Table of Contents