Advertisement
Adjust the pressure dial
to read 3.2 PSI which is
the operating pressure
of your Sea Eagle. PSI
is marked in red on the
dial. Never turn the dial
when the device is
under pressure as this
will immediately cause
the instrument to break.
Connect the cord at the
end of the power supply
into the end of the cord
attached to the pump.
Connect the Turbo
Pump to a 12V battery
(car or marine) using
the alligator clips at the
end of the extension
cord. Connect the red
clip to the positive pole
and the black clip to the
negative pole.
If you ordered the Turbo
Pump Kit you can also
connect the pump to the
portable battery in place
of the alligator clips.
5
To charge the portable
battery, plug it into the
charger and then plug
the charger into a
household electrical
outlet. The light on the
battery charger will blink
red until fully charged.
When it is fully charged
the light will be a solid
green.
It is recommended to
keep the Turbo Pump
inside of the carry bag
to make transportation
easier and to protect the
pump from sand which
could jam it. The carry
bag comes equipped
with compartments for
the pump, battery and
charger.
Press the ON button to
begin inflation. The
pump operates in two
stages which can be
identified by the noise of
the turbine at the start,
followed by the piston.
The pump automatically
stops once the pressure
is reached.
Air compressors that
are designed for other
uses like tire inflation
(usually around 50 PSI)
can easily harm your
Sea Eagle which works
at a much lower pres-
sure of 3.2 PSI. For this
reason we recommend
only using Sea Eagle
pumps.
Advertisement
