Sea Eagle Boats SE330 Instruction & Owner's Manual
Sport kayaks
Hide thumbs
Also See for SE330:
- Instruction & owner's manual (10 pages) ,
- Instruction & owner's manual (12 pages)
Related Manuals for Sea Eagle Boats SE330
Summary of Contents for Sea Eagle Boats SE330
- Page 1 Sport Kayaks SE330 & SE370 Instructions & Owner’s Manual Sea Eagle Boats, Inc. 19 N. Columbia Street, Suite 1 Port Jeff erson, NY 11777 1-800-748-8066 September 2016...
- Page 2 Congratulations on purchasing a Sea Eagle! With over 45 years of experience in designing, selling and using these quality inflatables, we’re confident that you are going to love your Sea Eagle and we’re ready to proudly stand behind them. Manufacture’s Certifications Our kayaks comply with ISO 6185 standard established by the International Organization for Standardization.
- Page 3 Feel free to give us a call at 1-800-748-8066 and we will be happy to talk with you! Our business hours are Monday to Friday from 9AM to 5PM, EST. Sea Eagle Boats Inc. 19 N. Columbia Street, Suite 1 Port Jefferson NY 11777 1-800-748-8066 staff@seaeagle.com...
- Page 4 Safety In a manual of this type, it is impossible to give adequate space to the topic of water safety. For further information on boating safety, visit USCGBoating.org or enroll in a water safety course by a local provider. It is your responsibility to be aware of and comply with all relevant safety regulations. For all water recreation or sport, you should have reasonable swimming abilities.
- Page 5 Operating Your Sea Eagle Lake & Stream Paddling • Keep drain valve closed tightly and properly to keep water out of the kayak • Start off slowly • Hold your paddle out in front of you with your arms as straight as possible •...
- Page 6 Infl ation & Set Up INFLATION: Valves & Pumps Insert the larger Roll out kayak on a end of the wide hazard free, fl at adapter into the surface. hose and twist to Remove the White lock in place. Valves from the plastic bag.
- Page 7 INFLATION: Inflation & Set-Up First, make sure Locate the 3 main the pump is valves at the stern switched OFF (back). Labeled before inserting the in the photo is the power adapter into fl oor chamber (#1), car’s power outlet. and the two side chambers (#2 and 3).
- Page 8 Seat Placement If paddling solo, position the seat just If the Infl ation Monitor aft of the kayak’s is lost, a ruler can be mid-point. used (10cm or 4”). If paddling tandem, position the rear seat as far back as seat as far back as possible and the front possible and the front...
- Page 9 Fold s tarting from The additional holes the bow (front). in the shaft are for Ensure compact “feathering” the storage by folding blades. Blades can be tightly from the offset from each other start. At the end, to make paddling into tuck the bow a stiff breeze easier into the hull and...
-
Page 10: Troubleshooting
Diaphragm Troubleshooting: Air Leaks Check the black If your boat is losing air it doesn’t necessarily mean diaphragm at the that it has a hole. For instance a boat that is inflated bottom of the inner late in the day with 90° air may cool 20° overnight. valve for grains of sand and other The cooler air will exert less pressure on the hull and... - Page 11 Patching Using a hair dryer, Leaks that are larger warm the skeg until than a pinhole can the curve becomes be patched. Most soft & pliable. This patches can be done should only take in a few minutes, but about 2-3 minutes we do off er a repair on a normal setting.
- Page 12 QuikSail OPTIONAL) Place the patch on Converts any kayak the damaged area into a sailing vessel. and press down Easily deploys in under fi rmly. Let the glue sit one minute, breaks for 2-4 minutes until down to just 43” for it appears tacky.
Need help?
Do you have a question about the SE330 and is the answer not in the manual?
Questions and answers