Disassemble The Control Head - Motorola GTX/LCS 2000 Service Manual

Disassemble the Control
Head
CLIPS
GASKET
SPEAKER
FLAT CABLE
1. To pull out the printed circuit board from the control head hous-
ing, insert a small blade screw driver in the side groove near the
four protruding tabs. Remove the board from the control head
housing.
2. Disconnect the board from the speaker by removing it from the
socket.
3. Remove the keypad from the control head housing by lifting it
up from the board. Care should be taken not to touch or get other
contaminates on the conductive pads on the under side of the
keypad or conductive contacts on the printed circuit board.
4. Take the LCD frame out of the control head.
SHIELD
Figure 5-4 Main Board Removal
HOUSING
LCD FRAME
ZEBRA CONNECTOR
KEYPAD
POTENTIOMETER
Figure 5-5 Control Head Removal
Disassembly & Reassembly
PART OF LCD FRAME
VOLUME KNOB
TAB
5-3