Indicator Lamp; Selector Lever Positions - BMW M6 Owner's Manual

Handbrake
The handbrake is primarily intended to prevent
the vehicle from rolling while parked; it brakes
the rear wheels.

Indicator lamp

The indicator lamp lights up, and a
signal also sounds when starting off.
The handbrake is engaged.
Indicator lamp for Canadian models.
Engaging
The lever engages automatically.
Releasing
Pull slightly upwards, press the button and
lower the lever.
If exceptional circumstances should
make it necessary to engage the hand-
brake while the vehicle is in motion, do not pull it
too strongly. In doing so, continuously press the
button of the handbrake lever. Otherwise,
excessive pressure can lead to the rear wheels
locking up and loss of traction – fishtailing – at
the rear axle.<
To prevent corrosion and one-sided brak-
ing action, occasionally engage the hand-
brake lightly when the vehicle is slowly coming
to a stop if the traffic conditions are suitable.
The brake lamps do not light up when the hand-
brake is engaged.<
Online Edition for Part no. 01 41 0 012 830 - © 08/06 BMW AG
Sequential Manual
Transmission with Drivelogic
The concept
The SMG Sequential Manual Transmission
with Drivelogic is an automated manual trans-
mission in which an electrohydraulic system
handles the clutching and gear changes.
The Sequential Manual Transmission is oper-
ated with the selector lever and two shift pad-
dles on the steering wheel.
It offers the following functions:
> Choice of manual or automatic mode:
Sequential mode or Drive mode
> Selection option between different driving
programs, Drivelogic, refer to page
> Upshift display, shift lights, refer to page
> Automatic downshifting and prevention of
incorrect shifting even in sequential opera-
tion
> Automatic double clutching

Selector lever positions

> R: Reverse gear
> N: Neutral, idle
> Β: Drive position:
> +: manual upshifting
> –: manual downshifting
> D/S: switch between Drive mode and
Sequential mode
Shiftlock
Press the brake pedal before shifting out of N;
the shift command will not be executed unless
the brake is applied.
61
62
59