Wir Ing De Scrip Tions; Pas Sen Ger Com Part Ment Con Nec Tions; Con Trol Unit And An Tenna; Door Trig Ger/In Te Rior Light Sup Ply - Clifford Ace 2000 Installation Manual

Wir ing De scrip tion for the 2- pin Con nec tor
Pin Wire Color
1 White/Red
2 White/Red
Wir ing De scrip tion for the 20- pin Con nec tor
Pin Wire Color
1 Gray
2 White
3 Orange
4 Gray/Yellow
5 Blue
6 Violet
7 White/Brown
8 Black
9 Black
10 Red
11 Brown/White
12 Gray/Green
13 Gray/Orange
14 Green
15 Gray/Violet
16 Yellow
17 Brown
18 Brown
19 Red/White
20 Red

Pas sen ger Com part ment Con nec tions

The ACE 2000 con trol unit must be in stalled in side the ve hi cle. Un der no
cir cum stances should the unit be in stalled un der the hood or other simi larly
hos tile en vi ron ment.
1. Select an area behind the dash to mount the control unit using wire ties, but do not
permanently affix it until all wiring and testing is complete.
2. Plug the 18" CliffNet DataPort Extension Cable into the control unit. Make sure the
receptacle end will be easily accessible after the dash has been secured back to its original
position. This extension cable ensures ease of service later on.
3. Run the antenna either up the window pillar or under the dash, away from metal. Do not
fold the excess cable or antenna wire. Do not make hard, sharp bends.

Door Trig ger/In te rior Light Sup ply

Door triggers on most autos are negative (except most Rolls-Royce and Ford autos). To
determine door trigger polarity, use the following procedure:
1. Find the wire coming off the rear of the vehicle door switch.
2. Connect the negative voltmeter lead to ground.
3. Find the one wire that shows +12 volts when the switch is pressed in and 0 volts when
released. This is a negative trigger door wire.
4. If you don't get the indications noted in step 3, find the one wire that shows 0 volts when
the switch is pressed in and +12 volts when released. This is a positive trigger door wire.
5. Connect the system's thin GRAY wire to the door wire.
6. If the door trigger is negative, no further installation is required.
Con nects to
Starter or Ignition Interrupt - key side
Starter or Ignition Interrupt - starter or ignition side
Con nects to
Door trigger input (+) or (-)
Valet Switch input (-)
Sensor input trigger zone (-)
trunk and hood trigger input (-)
Sensor input warning zone (-)
LED output (+)
Ignition Input
Ground for the Dual-Zone Piezo Sensor, optional sensor and LED
connectors, Valet Switch
Battery Negative
Power for the Dual-Zone Piezo Sensor, optional sensor
Interior light output (-)
Door lock output (+) or (-)
Door unlock output (+) or (-)
Armed output (-)
Auxilliary A output (-)
Siren output (-)
Parking light output (+)
Parking light output (+)
Battery positive with 20 Amp fuse
Battery positive with 5 Amp fuse

Con trol Unit and An tenna

5