Reference Information; Structure Of The Main Body; Stop Lever [Tool Retainer] - Hitachi HAMMER H 65SC Technical Data And Service Manual

8. REFERENCE INFORMATION

8-1. Structure of the Main Body

The primary structure of the Model H 65SC is similar with the Model PH-65A, as illustrated. (Fig. 3)
Front Cover
Stop Lever
Shank Sleeve
Mouth
Cylinder Case
8-2. Stop Lever [Tool Retainer] (Fig. 4 and Fig. 5)
(1) Clean, then smear the tool shank with
grease or machine oil. (Fig. 4)
(2) Rotate the stop lever 180˚ in a
clockwise direction while pulling it
toward you. Next, insert the tool shank
into the hexagonal hole on the front
cover. (Fig. 4)
(3) Clamp the tool by turning the stop lever
by half a turn in the opposite direction.
(Fig. 5)
Striker
L Ring
Piston Pin
Connecting Rod
Piston
Housing Ass'y
Gear Cover Ass'y
Crank Shaft
Final Gear
Felt Holder (C)
Ass'y
Armature Ass'y
Fig. 3
Hold the tool with its flattened
part directed upward.
Tool Shank
--- 9 ---
Inner Cover
Counter Gear Switch Handle
Stator Ass'y
Front Cover
2
Stop Lever
3
1
Fig. 4
Stop Lever
Fig. 5