Table of Contents
Advertisement
CARTON CONTENTS
Check carton contents against the following list:
S Brushcutter
S Tube mounting screws (2)
S Tube mounting nuts (2)
S Handlebar screws (2)
S Blade guard screws (4)
S Cupped washer (1)
S Large nut for installing blade (1)
S Long hex key wrench (1)
S Short hex key wrench (1)
S Bracket cover
S Guard for use with blade
S Shoulder strap with warning
S Brush blade
S Handlebar
WARNING:
Always stop unit and dis-
connect spark plug before performing any as-
sembly procedures.
WARNING:
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
It is normal for the fuel filter to rattle in the
empty fuel tank.
Finding fuel or oil residue on muffler is normal
due to carburetor adjustments and testing
done by the manufacturer.
TOOLS REQUIRED
S 2 hex key wrenches (provided)
S Adjustable wrench or large pliers
S Phillips screwdriver
ATTACH THE TUBE
NOTE:
A drive shaft is located in the center of
the tube. Make sure this shaft does not fall out of
the tube. Dirt on the shaft will significantly re-
duce the life of the unit. If this shaft falls out,
clean, relubricate, and re-install.
1. Insert the 2 tube assembly screws and
nuts in the nose cone. Tighten with a hex
wrench just enough to hold the parts to-
gether.
2. Some units may include a plastic cover
over the end of the tube. If your unit in-
cludes any covering, remove the cover at
this time.
3. Pull about 1/2 inch of the drive shaft out of
the inside of the tube.
ASSEMBLY
If received assembled,
Drive shaft
NOTE:
The end of the tube has a groove that
aligns with a ridge in the engine opening. Lo-
cate the groove and ridge.
4. Align the groove in the tube with the ridge
in the engine opening. Insert the tube into
the opening.
5. Firmly push the tube into engine until it will
no longer go into the opening.
6. Tighten screws alternately with the hex
wrench until secure.
ATTACHING THE HANDLEBAR
DANGER:
handlebar must be installed as shown to pro-
vide a barrier between operator and the spin-
ning blade.
1. Locate the decal on the handlebar. This
decal includes two arrows. Position the
handlebar on the mounting bracket be-
tween these arrows.
2. Position the bracket cover over the han-
dlebar. Again make sure the handlebar is
between the arrows.
3. Insert screws and hand tighten only.
These screws will be tightened later.
Bracket Cover
Mounting
Bracket
5
Ridge
Groove
The barrier portion of the
Screw
Handlebar
Hide quick links:
Advertisement
Table of Contents
