Control Panel Operation; Safety Instructions; Installation - SPT ICEMAKER-28 Instruction Manual

CONTROL PANEL OPERATION

Press to turn unit ON
START
Also used to start the ice making cycle
Press to turn unit OFF
STOP
CUBE SIZE SELECTION of Small, Medium or Large.
SELECT
(The selected size will remain unless changed or
when there is a power failure.) Default setting is
Medium. NOTE: When ambient temperature is
around 59° ° ° ° F – please select SMALL size.
ADD WATER indicator will lit and a long beep will go
ADD
off when water in the reservoir is low and needs to be
WATER
refilled. Press STOP, add water, then press START to
restart the icemaker. Or when the water has reached
the fill line, the unit will restart automatically.
ICE FULL indicator will lit and two short beeps will go
ICE
off when the ice basket has reached the maximum
FULL
storage capacity.
IMPORTANT: Before you refill water or remove ice, you must
press STOP first. When done press START to restart the unit.
3

SAFETY INSTRUCTIONS

WARNING: To reduce the risk of fire, electric shock or injury when
using your icemaker, please follow these basic precautions.
• Plug in grounded 3-prong outlet only
• Do not remove ground prong
• Do not use an adapter
• Do not use extension cord
• Disconnect power before maintenance
• Do not pull on the cord when plugging and unplugging unit

INSTALLATION

• During transportation, the incline angle of the cabinet should not
exceed 45°.
• Do not turn the unit upside down, compressor and sealed
system problems can occur.
• Place the unit on a flat and leveled surface.
• To ensure proper ventilation, keep 6" of space between the
sides and the wall.
BEFORE INITIAL USE:
• Remove all interior and exterior packing materials.
• Please allow unit to sit for at least 2 hours.
• Clean the inner liner, ice basket, water box, ice shovel with
damp cloth.
4