Two-Piece Front Turn Signal Lamps - Chevrolet S10 Pickup 2003 Owner's Manual

Two-Piece Front Turn Signal Lamps

1. Remove the headlamp assembly as shown in
"Two–Piece Composite Headlamp System"
under Headlamps on page 5-54
3. Unplug the electrical connector.
2. Locate the locking tabs
on the assembly.
Squeeze the tabs
together and push that
end of the assembly
out while holding
the tabs. The assembly
will swing out.
4. Turn the harness bulb socket counterclockwise to
remove it. Pull the bulb straight out to remove it
from the socket.
5. Push the new bulb into the socket until it snaps into
place.
6. Put the socket into the lamp assembly and turn it
clockwise until it is tight.
7. To reinstall the assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then
swing the assembly in and snap it into place.
8. Install the two retaining clips.
9. Close the hood.
5-57