Cassette Playback - Hyundai H-1004 Instruction Manual

Instruction manual
Cassette operation
Controls
• STOP/EJECT button
During operation, press to stop all deck
operation. Press again to open the cassette
door.
• F.FWD button and REWIND button
Press to rapidly advance the tape in either
forward or reverse direction.
• PLAY button
Press to start playback.
• PAUSE button
Press to stop tape operation temporarily.
Press again to resume tape operation.
• RECORD button
Press to start recording. PLAY button will be
activated automatically.

Cassette playback

Slide Function switch to TAPE position.
Press STOP/EJECT button to open the
cassette compartment. Insert a cassette with
tape facing upwards and push the cassette
door to close the cassette compartment. Press
PLAY button to start the playing.
When the tape plays to the end, playing
will be stopped automatically.
Recording
Recording from radio
• Slide Function switch to RADIO position.
• Tune to the desired radio station.
• Insert a blank cassette into cassette
compartment with tape facing upwards.
• Press RECORD button to start recording.
PLAY button will be pressed automatically.
• To pause recording, press PAUSE button.
• Press STOP/EJECT button to stop
recording.
Recording from built-in microphone
• Slide Function switch to MIC position.
4
• Insert a blank cassette into cassette
compartment with tape facing upwards.
• Press RECORD button to start recording.
PLAY button will be pressed automatically.
• To pause recording, press PAUSE button.
• Press STOP/EJECT button to stop
recording.
Erasing
• Slide Function switch to TAPE position.
• Insert a cassette into cassette
compartment with tape facing upwards.
• Press RECORD button to start erasing.
PLAY button will be pressed automatically.
• Press STOP/EJECT button to stop
erasing.
Maintenance and care
• Check your batteries regularly; old or
discharged batteries should be replaced.
• Always unplug the appliance from power
supply, when not used for a long time.
• Electronic products of this kind should
never be subjected to moisture, dust or
extreme temperatures.
• Do not shake, hit or drop the unit.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• The heads and capstan are in constant
contact with the moving tape. Use a small
cotton bud with alcohol or special tape head
cleaner to clean these parts. Never touch the
heads with any metallic objects.
Erase protection
• To prevent accidental erasing of a
cassette, simply break off the two plastic tabs
located on the cassette tape's rear side.
• When a cassette with removed plastic tabs
is inserted, RECORD button cannot be pressed.
• If a cassette is to be erased and re-
recorded at a later stage, simply cover the