Battery Operation - Hyundai H-1004 Instruction Manual

Important safeguards
• Attention: The Instruction Manual
contains important operating and maintenance
instructions. For your safety, it is necessary to
refer to the manual.
• Dangerous voltage: Uninsulated
dangerous voltage that may be of sufficient
magnitude to constitute a risk of electrical
shock to persons is present within this product
enclosure. Make sure that pins or other foreign
objects do not get inside the unit; they may
cause malfunctions, or create safety hazards
such as electrical shock.
• Caution: Do not remove cover (or back).
Refer servicing to qualified service personnel.
Power supply

Battery operation

• The power cord should be disconnected.
• Open the battery compartment cover.
• Insert 4 UM-1 (D)-size batteries. Please
observe correct battery polarity, otherwise the
set will not work.
• Close the battery compartment cover.
AC operation
• Before the first connecting of the
appliance, check that voltage indicated on the
rating label corresponds to your local mains
voltage.
• Plug the corresponding end of the cord
into the AC power cord socket.
• Insert the plug into power supply.
• When the set is only used with AC or is
not used for 2 weeks or more, please remove
the batteries to avoid damage to the set from
leakage of batteries.
This unit cannot be operated by
batteries if the AC power cord is connected to
the unit.
Instruction manual
General operations
Function switch
• Set to RADIO for:
- Radio reception;
- Cassette recording from the radio;
• Set to TAPE for cassette playback;
• Set to MIC for recording from the built-in
microphone.
Volume adjustment
The volume level of sound reproduced by the
speakers is adjusted by rotating VOLUME knob.
During recording, adjusting the volume
only affects the monitor sound, not the content
of recording.
Stereo headphone use
For private listening, insert the plug of a
stereo headphone (not included) into the
phone jack. During use of headphones, the
built-in speakers will disconnect automatically.
Radio operation
Operation
• Set Function switch to RADIO position.
• Select the needed broadcasting band with
AM/FM switch.
• Rotate TUNING knob to find the needed
frequency.
• To turn off the radio, set Function switch to
TAPE or MIC position.
Antenna
• For FM reception, adjust the telescopic
antenna appropriately to obtain the best
reception on the band selected.
• AM signals are picked up through the built-
in ferrite antenna. The set should be placed to
a position for the best reception.
3