Fan Speed; Humidity Control; Other Indications - Essick EP9 500 Owner's Care & Use Manual

FAN SPEED

2) The Speed button controls
the variable speed motor.
Nine speeds provide precise
fan control. Press the power
button and select fan speed:
F1 through F9 proceeding
from low to high speed.
The fan speed will display on
the control panel as the
speeds are stepped through.
NOTE: When excessive condensation exists, a lower fan speed setting is
recommended.

HUMIDITY CONTROL

NOTE:
Allow 10 to 15 minutes for the humidistat to adjust to the room when setting
up the unit for the first time.
NOTE: The EP9 / EP9R Series has an automatic humidistat located on the cord that
measures the relative humidity in the room. When the selected humidity level drops
3% below the relative humidity, the humidifier cycles on and off as required to
maintain the selected setting.

OTHER INDICATIONS

4) This humidifier has a check filter reminder timed to appear after
720 hours of operation. When the Check Filter (CF) message is
displayed, disconnect the power cord and check the condition of
the filter. The CF function is reset after plugging the unit back in.
5) When the unit is out of water, a flashing F will display on the display
panel.
3)
7
At initial startup the
relative humidity of
the room will be
displayed.
Each successive
push of the Humidity
Control Button will
increase the setting
in 5% increments. At
65% set point, the
unit will operate
continuously.