Controls And Operation; Fan Speed; Humidity Control - Essick EA1201 Owner's Care & Use Manual

FILLING INFORMATION
8. Your humidifier is equipped with a
convenient front pour- in door. Use a
pitcher to fill the unit through the spout
door. When the door is opened an LED
light illuminates the MAX FILL line
inside. The reservoir holds 3.5 gallons.
Do Not Overfill.
NOTE: Fill unit with cool, fresh (preferably
unsoftened) water. If you only have softened
water available in your home, you can use it,
but mineral buildup will occur more quickly.
NOTE: On initial fill up, it will take approximately 20 minutes for the wick to
become fully saturated.

CONTROLS AND OPERATION

3. The digital touch screen panel allows you to control the fan speed and humidity
level by simply tapping the appropriate up or down arrow switch on the front of the
panel.
4. A digital display provides information on the status of the unit. Depending on which
function is being accessed, it displays ambient and set humidity, fan speed and
status of the unit.

FAN SPEED

5. Tap the up arrow or down arrow on the FAN SPEED section to adjust the fan.
The display will show F1 through F9 proceeding from low to high speed.
NOTE: When excessive condensation exists, a lower speed setting is recommended.

HUMIDITY CONTROL

NOTE: The EA1201 has an automatic humidistat that cycles the humidifier on and
off as required to maintain the selected setting.
6. At initial startup the ambient humidity of the room will be displayed.
7. Tap the up or down arrow in the HUMIDITY SET section of the panel to
adjust the humidity level in 5% increments. At 65% set point, the unit will
operate continuously.
5
1. Plug cord into wall
receptacle. Your
humidifier is now
ready for use. The
humidifier should not
be near any heat
registers.
2. Place the unit at least
FOUR inches away
from any walls.
Unrestricted airflow
into the unit will result
in the best efficiency
and performance.