RightWay Tony Stewart SPOTTER User Manual page 3

Tony stewart edition
Table of Contents

Advertisement

MOUNTING YOUR SPOTTER
MOUNTING YOUR SPOTTER
Your Spotter GPS Navigator can be easily secured to either the windshield or
the dash for optimal viewing while driving. The mounting system consists of
the following pieces:
Adjustable arm with suction cup
Navigator cradle
Dash disk with adhesive backing
Adjustable arm with suction cup
TO ATTACH THE MOUNT
Select a location for the mount on the windshield or dashboard that does not
obstruct the driver's view or interfere with the operation of the vehicle.
1. Attach clip to mount
2. Select a location for the mount on the windshield or dashboard that
does not obstruct the driver's view or interfere with the operation of the
vehicle.
3. Clean and dry this area to remove any grease and dirt.
If mounting the Spotter GPS Navigator on the dashboard, remove the
protective backing from the dash disc, exposing the adhesive. Adhere
the disc to the dashboard in the desired location.
The adhesive is permanent.
4
Dash disk with
Navigator Cradle
adhesive backing
4. Place the suction cup on the desired location on the
windshield or dash disc; push the locking lever towards
the base of the mount. The mount should stick to the
surface.
If your mount does not stick, make sure the area is
clean and dry, then try again.
5. Align the tabs on the holder with the slots on the Navigator cradle. Slide
together until the parts are firmly seated.
6. Adjust the holder to the best viewing angle by:
a.
Loosening the adjustor dials
b.
Moving the corresponding part to the desired position
c.
Tightening the adjustor dials.
7. Align the grooves on the bottom of your unit with the tabs on the bottom of
the navigator cradle; gently push the unit into the cradle until the unit clicks
into place.
8. To remove the Spotter GPS Navigator from the mount, gently push back the
tab on the top of the cradle until you hear a click releasing the unit.
TO DETACH THE MOUNT
1. Pull the locking lever away from the base of the mount.
2. Grasp the pull tab of the suction cup and gently pull away from the wind-
shield or dash to break the suction.
Caution!
It is illegal in Minnesota to attach anything to the windshield.
When using navigation aids in a vehicle, it is your sole responsibility to
place, secure and use these aids in a manner that will not cause accidents,
personal injury, property damage, or in any manner to obstruct your view.
You, the user of this product, are solely responsible for observing safe
driving practices.
5

Advertisement

Table of Contents
loading

Table of Contents