Recommended Original And Replacement Bar And Chain Combinations - Jonsered CS2186 Operator's Manual

Recommended original and replacement bar and chain combinations

These Jonsered chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Bar
Length, inch Pitch, inch
16-32 3/8
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
0,050"/1,3 mm - 72LP
0,058"/1,5mm S42 73LP
0,063"/1,6 mm - 75LP
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries to the
!
user. Do not operate this saw unless you have extraordinary cutting needs and experience and
specialized training for dealing with kickback. Saws with significantly reduced kickback potential are
available. Always use the safest saw and cutting equipment applicable to your cutting need.
TECHNICAL DATA
Chain
Max. nose radius
11T Jonsered S42, Oregon 73LP/73LG
72LG
73LG
75LG
– 37
English