Contact IMpORTanT: Refer to the sections on installation your local dealer, distributor, or call Community directly for and connections later in this manual for additional assistance. These terms are defined as: information on rigging and electrical safety.
Warranty Information ................15 InTROducTIOn Thank you for your selection of Community’s WET X Series Loudspeakers. This manual is intended to help you install and use WET X loudspeakers safely and effectively. It provides useful information to help you obtain the best performance, sound quality, and reliability from your WET X system.
Any modifications made to any parts or materials manufactured or supplied by Community shall immediately void all pledges of warranty or surety, related in any way to the safe use of those parts and materials.
180°, and reattached so that the Community logo is at the bottom. There are a number of screws around the perimeter of the enclosure, remove them, lift the grille off, rotate it, then replace it and reattach using all of the screws.
MOunT ThE lOudSpEakER (cont'd) stated enclosure IP54 rating. There are degree marks on the q Attach the provided 2" gaskets to the inside surface of the bracket arms. With the adhesive side facing the inside outside of the bracket slot to help keep the angle consistent. of the bracket, align with the large hole and press into place.
The selection of appropriate electrical hardware to interface with the WET X loudspeaker lies solely with the installation professional. Community recommends that an appropriately licensed engineer, electrician, or other qualified professional identify and select the appropriate conduit, fittings, wire, etc.
MaInTaInIng WEaThER RESISTancE Note: Additional mounting patterns are offered as a Configure-to-Order (CTO) option. Consult your Community guIdElInES FOR WET X OuTdOOR uSE representative and structural engineer for the recommended WET X is suitable for outdoor installation when used as bracket or mounting system.
TEchnIcal dRaWIngS TypIcal 12-Inch 2-Way lOudSpEakER 4.63" (117 mm) Center of Gravity 12.90" (327 mm) Center 1/2"-13 Hang Point of Load Center of Gravity 16.0" (406 mm) 1/4"-20 Bracket Locking Point 15.0" 9.5" (241 mm) (381 mm) 30.50" (774 mm) FROnT SIdES Center of Gravity...
Page 12
TEchnIcal dRaWIngS TypIcal 15-Inch 2-Way lOudSpEakER 4.63" (118 mm) Center of Gravity 1/2"-13 Hang Point 15" (381) Center of Gravity 19.5" (495 mm) 1/4"-20 Bracket Locking Point 17.13" (435 mm) 11.5" (292 mm) 33.63" (854 mm) FROnT SIdES 12.25" (286 mm) Top of Cabinet 2.0"...
For more information on installing and operating your removal of the LF driver or the horn assembly. Take note WET X loudspeaker, please refer to Community’s website at of wiring positions prior to removing any drivers from the www.communitypro.com. For application support, service loudspeaker.
SpEcIFIcaTIOnS MOdEl WX-1226 WX-1264 WX-1266 WX-1294 WX-1296 WX-1299 2-way, full-range loudspeaker Type LF: 1 x 12" weather-treated cone, HF: 1 x 1.4" exit driver driver complement 120° x 60° 60° x 40° 60° x 60° 90° x 40° 90° x 60°...
Ec STaTEMEnT OF cOnFORMITy This document confirms that the range of products of Community Professional Loudspeakers bearing the CE label meets all of the requirements in the EMC directive 89/336/EEC laid down by the Member States Council for adjustment of legal requirements.
Page 16
Note: Every effort has been made to insure that the information contained in this manual was complete and accurate at the time of printing. However, due to ongoing technical advances, changes or modifications may have occurred that are not covered in this manual. Visit Community at www.communitypro.com for the latest version of this manual and the most recent product information.
Need help?
Do you have a question about the WX-1226 and is the answer not in the manual?
Questions and answers