Table of Contents
Advertisement
MAKE SURE YOU HAVE RECEIVED ALL PARTS:
Check your packing list to verify that all listed parts have been received. You should have the following:
• Unvented gas log burner assembly
• Installation/operating instructions
• Refractory Cement Logs
The millivolt controlled version of this heater is the only style designed to be operated with optional devices for ON/OFF
functions. The following options may be used with the millivolt controlled heater. These options are not packaged with
the log set.
• Hand held Remote with receiver
• Wall switch with 15' wire
• Handle the gas log burner assembly by the frame only. Do not pick the
unit up by the burners or grate (not attached to frame).
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer
from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts
in good condition.
WHAT YOU WILL NEED FOR INSTALLATION:
You must have the following items available before proceeding with installation:
• External regulator (for propane/LPG and 1/2 lb. natural gas systems only)
• Piping which complies with local codes
• Screwdriver
• Drill with 5/32 bit
• Manual shutoff valve
• Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)
• Pipe wrench or appropriate size crescent wrench set
• Tee joint.
• Sediment trap
65D2035
• Plastic bag containing crushed volcanic rock
• Two (2) anchoring screws
• Grate
• Wall thermostat with 15' wire
• Hand held Thermostat Remote with receiver
GETTING STARTED
5
Hide quick links:
Advertisement
Table of Contents
