Cylinder Head Bolt Torque Specification - NorthStar 25654 Owner's Manual

IMPORTANT
If a part needs replacement, only use parts that meet
the manufacturer's part number specifications.
Replacement parts that do not meet specifications
may result in a safety hazard or poor operation of the
compressor. Major service, including installation or
replacement of parts, should be made by a qualified
electrical service technician.

Cylinder Head Bolt Torque Specification

The recommended torque to tighten cylinder head
bolts is 9~11 ft.-lbs. Bolts should be tightened
according to the following sequence:
1-4-2-3-1. (Figure 10)
Figure 10
Contact NorthStar Product Support at 1-800-270-0810
For any questions, problems, or parts orders.
14