Description Of Schematic Diagram - Sharp 25VT-J100 Service Manual

DESCRIPTION OF SCHEMATIC DIAGRAM

NOTES:
1. The unit of resistance "ohm" is omitted
H
(K:1000 ohms, M:1 Meg ohm).
2. All resistors are 1/8 watt, unless otherwise noted.
3. All capacitors are µ F, unless otherwise noted P: µµ F.
4. (G) indicates ±2% tolerance may be used.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
G
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000 µ V B&W or Color
signal.
F
WAVE FORMS
E
D
C
B
A
1 2 3
25VT-J100
25VT-CJ10
WAVEFORM MEASUREMENT CONDITIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2. indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
å AND SHADED ( ) COMPONENTS
= SAFETY RELATED PARTS.
ç
MARK= X-RAY RELATED PARTS.
DRGANNES MARQUES-ET HACHRES (
PIECES RELATIVES A LA SECURITE.
MARQUE ç : PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed
circuits may be subject to change for product
improvement without prior notice.
4 5
31
25VT-J100
25VT-CJ10
SCHEMATIC DIAGRAM :
H
G
):
F
E
D
SUB POWER
C
B
A
6 7 1 8 2
VCR KEY, POWER SW, CRT, SUB POWER Unit
(25VT-CJ10. ONLY)
9 3 10 4 11 5
32
12 6