Table of Contents
Advertisement
Connecting the Hob to the Mains Power Supply
The socket should be connected in compliance with the relevant standard,or a single-pole circuit breaker. The
method of connection is shown below.
L
L
1.
If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper
tools, so as to avoid any accidents.
2.
If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be
installed with a minimum gap of 3mm between the contacts.
3.
The installer must ensure that the correct electrical connection has been made and that it complies with
safety regulations.
4.
The cable must not be bent or compressed.
5.
The cable must be checked regularly and only replaced by a properly qualified person.
CSPHOBW10_IB_final110415.indd 13
N
3 × 6mm
• This appliance must be earthed.
• For this connection a power lead of
N
/ 3 × 2.5mm
2
2
wire type H05VV-F should be used.
13
15/04/2011 1:55 PM
Advertisement
Table of Contents
Need help?
Do you have a question about the CSPHOBW10 and is the answer not in the manual?
Questions and answers