Remote Programming; Programming Options - Clifford 4115X Owner's Manual

Remote Programming

1. Turn key to the ON position
2. Within 10 seconds, press and release Valet button one time.
3. Within 10 seconds, press and hold the Valet button. The LED on the mod-
ule flashes one time and the horn honks (if connected) to confirm entry into
remote programming. Do not release the valet button.
4. Press the button on the remote control. The horn honks to confirm the remote
has been programmed.
5. Release the Valet button.
6. Turn the key to the Off position. The horn sounds one long honk to confirm
that remote programming has been exited.
The programming routine exits if any of the following occurs:
The ignition is turned off
There is no activity for 30 seconds
The Valet button is pressed too many times

Programming Options

Programming options control your system's normal operational set-up.
Most options do not require additional parts, but some may require
installation labor.
The following is a list of the programmable options, with the factory
settings in bold.
Your system can be programmed to allow the vehicle to run for
up to 60 minutes when remote started. Can be set up to minute
increments by your installer.
Parking lights flashing or constant. Your system can be pro-
grammed to flash or turn on the parking lights constantly during the
entire remote start operation.
8 © 2013 Directed. All rights reserved.